Kia Carens. Instruction — part 319
2001 > 1.8L DOHC >
REMOVAL
1. Discharge refrigeration system. (Refer to operating instructions of your refrigerant recovery/recycling
/charging station for proper procedures.)
2. Remove receiver/drier a shown in figure.
Immediately plug open fittings to keep moisture out of system
INSTALLATION
Install receiver/drier in reverse order of removal.
1) Apply clean compressor oil to O-rings before connecting fittings.
2) Do not apply compressor oil to fitting nuts.
3) When installing a new receiver/drier, add compressor oil through high-pressure pipe port of
compressor.
Compressor oil: 0.61 cu in (10 cc)
Tightening torque
Receiver/drier inlet: 43~61 lb-in (4.9~6.9 N0m, 50~70 kg-cm)
Receiver/drier outlet: 43~61 lb-in (4.9~6.9 N-m, 50~70 kg-cm)
Heating,Ventilation, Air Conditioning
Air Conditioning System - A/C Control Relay
Heating,Ventilation, Air Conditioning
2001 > 1.8L DOHC >
INSPECTION
A/C relay
1. Disconnect A/C relay connector.
2. Check continuity between terminals.
Terminals
Continuity
Tester probe: +
Tester probe: -
85
86
Yes
85
87
No
85
30
No
87
86
No
87
30
No
3. If not as specified, replace relay.
4. If correct, go to next step.
5. Apply 12V to terminal 85 and ground terminal 86.
6. Check for continuity between terminals 87 and 30.
Terminals
Continuity
87-30
Yes
7. If not as specified, replace relay.
Heating,Ventilation, Air Conditioning
Air Conditioning System - Refrigerant Line
Heating,Ventilation, Air Conditioning
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст