Kia Carnival (2009+). Instruction — part 569
13
Hi - Scan
14
Hazard Select
15
Incar Motor (-)
16
GND
2009 > G 2.7 DOHC >
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the center air vent. (Refer to BD group)
3. Remove the heater & A/C controller (A) after loosening 4 screws.
4. Remove the heater & A/C controller (A).
5. Installation is the reverse order of removal.
2009 > G 2.7 DOHC >
SELFDIAGNOSIS
1. Self-diagnosis process
2. How to read self-diagnostic code
After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setup
temperature display panel every 0.5 second and will show two figures. Codes are displayed in numerical format
Fault code
Display
Fail description
00
NORMAL
11
IN CAR SENSOR OPEN (HIGH)
12
IN CAR SENSOR SHORT (LOW)
13
AMBIENT SENSOR OPEN (HIGH)
14
AMBIENT SENSOR SHORT (LOW)
15
WATER TEMP SENSOR OPEN (HIGH)
16
WATER TEMP SENSOR SHORT (LOW)
17
EVAP SENSOR OPEN (HIGH)
18
EVAP SENSOR SHORT (LOW)
19
TEMP DOOR POTENTIOMETER OPEN/SHORT (DR)
20
TEMP DOOR POTENTIOMETER FAULT
21
MODE DOOR POTENTIOMETER OPEN/SHORT (DR)
22
MODE DOOR POTENTIOMETER FAULT
23
HUMIDITY SENSOR OPEN (HIGH)
24
HUMIDITY SENSOR SHORT (LOW)
25
INTAKE DOOR POTENTIOMETER OPEN/SHORT
26
INTAKE DOOR POTENTIOMETER FAULT
32
TEMP DOOR POTENTIOMETER OPEN/SHORT (PA)
33
TEMP DOOR POTENTIOMETER FAULT (PA)
34
MODE DOOR POTENTIOMETER OPEN/SHORT (PA)
35
MODE DOOR POTENTIOMETER FAULT (PA)
36
TEMP DOOR POTENTIOMETER OPEN/SHORT (REAR)
37
TEMP DOOR POTENTIOMETER FAULT (REAR)
38
MODE DOOR POTENTIOMETER OPEN/SHORT (REAR)
39
MODE DOOR POTENTIOMETER FAULT (REAR)
3. Fault code display
(1) Continuance operation : DTC code is one.
(2) Continuance operation : DTC code is more two.
(3) STEP operation
A. Nomal or one fault code is same as a continuance operation.
B. DTC code os more two.
4. Diagnostic procedure refer to DTC code.
5. Fail safe
(1) In-car temperature sensor: Control with the value of 25°C(77°F)
(2) Ambient temperature sensor: Control with the value of 20°C(67°F)
(3) Evaporator temperature sensor: Control with the value of -2°C(28.4°F)
(4) Humidity sensor: Control with the value of 10%
(5) Temperature sensor : Control with the value of -2°C (28.4°F)
(6) Temperature control actuator (Air mix potentiometer):
If temperature setting 17°C-24.5°C, fix at maximum cooling position.
If temperature setting 25°C-32°C, fix at maximum heating position.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст