Kia Carnival (2009+). Instruction — part 110

The bottom side bolt(A) which can be seen after removing the under cover should be loosened for removal of
the radiator support upper member assembly.

20. Remove the under cover(A).

21. Drian engine oil.

22. Coolant should be drained before heater hose removal.

23. Remove front exhaust pipe(A).

24. Disconnect the wheel speed sensor and the stabilizer bar link(Refer to SS group).

25. Remove the caliper assembly and suspend it with a wire(Refer to DS group).

26. Supporting the engine and transaxle assembly with sub frame, remove the engine mounting bracket(A).

27. Remove the transaxle insulator mounting bolt(A).

28. Supporting the engine and transaxle assembly with a jack, remove the sub frame with the engine and transaxle

assembly.

When remove the engine and transaxle assembly, be careful not to damage any surrounding parts or body
components.

INSTALLATION

Installation is in the reverse order of removal.
Perform the following :

• Adjust the shift cable.
• Refill the engine with engine oil.
• Refill the transaxle with fluid.
• Refill the radiator with engine coolant.
• Bleed air from the cooling system with the heater valve open.
• Clean the battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent

corrosion.

• Inspect for fuel leakage.

After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for
approximately two seconds and fuel line pressurizes.
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.

Engine Mechanical System

Cylinder Block

Engine Mechanical System

2009 > G 3.8 DOHC >

COMPONENTS