Kia Carnival (2009+). Instruction — part 553
2009 > G 2.7 DOHC >
COMPONENT LOCATION
2009 > G 2.7 DOHC >
DESCRIPTION
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode
select switch makes the mode control actuator shift in order of vent! B/L ! floor ! mix.
2009 > G 2.7 DOHC >
INSPECTION
1. Ignition "OFF"
2. Disconnect the connector of mode control actuator.
3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 1 and
grounding terminal 2.
4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
[DRIVER]
[PASSENGER]
5. Check the voltage between terminals 3 and 4.
Door position
Voltage (3-4)
Error detecting
Vent
0.4 ± 0.15V
Low voltage :0.1V or less
Defrost
4.6 ± 0.15V
High voltage :4.9V or more
It will feedback current position of actuator to controls.
6. If the measured voltage is not specification, substitute with a known-good mode control actuator and check for
proper operation.
7. If the problem is corrected, replace the mode control actuator.
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the driver’s crush pad lower panel (Refer to BD group).
3. Disconnect the temperature control actuator connector (A) after removing the air duct.
4. Loosen the mounting screw and then remove the temperature control actuator (B).
[Passenger's]
[Driver's]
5. Installation is the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст