Kia Carnival (2009+). Instruction — part 194

(5) Connect the MAPS(Manifold Absolute Pressure Sensor) connector(A), the ETC(Electronic Throttle Control)

connector(B) and the PCSV(Purge Control Solenoid Valve) connector(C).

(6) Connect the injection harness connector(A), the No.2 VIS(Variable Induction System) connector(B), the

No.1/No.2 OCV(Oil Control Valve) connectors(C,D) and the OTS(Oil Temperature Sensor) connector(E).

(7) Connect the injection connectors(A,B,C), the ground lines(D), the condensor connector(E) and the Ignition coil

connectors(F).

(8) Connect the bank 1 front/rear O2 sensor connectors(A).

(9) Connect the No.1/No.2 knock sensor connectors(A,B), the oil pressure switch connector(C), the ignition coil

harness(D) and the No.1 VIS(Variable Induction System) connector(E).

23. Install the fuel inlet hose(A) from the delivery pipe.

24. Install the upper radiator hose(A) and lower radiator hose(B).

25. Install the intake air hose and air cleaner assembly.

(1) Install the intake air hose and air cleaner assembly(C).

(2) Connect the breather hose(B) from air cleaner hose.

(3) Connect the MAF connector(A).

26. Install the engine cover.

27. Refill engine coolant.

DISASSEMBLY

Identify MLA(Mechanical Lash Adjuster), valves and valve springs as they are removed so that each item can be
reinstalled in its original position.

1. Remove MLA(Mechanical Lash Adjuster)s(A).

2. Remove valves.

(1) Using SST(09222-3K000, 09222-3C300), compress the valve spring and remove retainer lock.

(2) Remove the spring retainer.

(3) Remove the valve spring.

(4) Remove the valve.

(5) Using SST(09222-29000), remove the valve stem seal.

Do not reuse the removed valve stem seals.

3. Remove OCV(Oil Control Valve)(A).

INSPECTION

CYLINDER HEAD

1. Inspect for flatness.

Using a precision straight edge and feeler gauge, measure the surface contacting cylinder block and the manifolds
for warpage.

Flatness of cylinder head gasket surface
Standard : 0.03mm(0.0012in.) or less