Kia Carnival (2009+). Instruction — part 495

INITIALIZING METHOD OF THE SAFETY POWER WINDOW

1. Initializing of Battery Connection

(1) Power window operation before initializing

A. Manual-Up/Down function is available
B. Auto-Up function is not available

(When holding the auto-up/down switch, window is operated as a manual-up/down.)

(2) Initializing method

Close the window in window open position, and holding the switch in window full close position more than 1
second.

2009 > G 2.7 DOHC >

REPLACEMENT

FRONT POWER WINDOW MOTOR

1. Remove (-) negative battery terminal.

2. Remove the front door trim panel. (Refer to the Body group-front door)

3. Remove the window motor (B) after disconnecting the motor connector (A) and mounting nuts.

4. Installation is the reverse of removal.

SLIDING POWER WINDOW MOTOR

1. Remove (-) negative battery terminal.

2. Remove the sliding door trim panel. (Refer to the Body group-rear door)

3. Remove the door trim seal and glass.

4. Remove the door regulator.

5. Remove the power window motor (A) after disconnecting the motor connector and power window motor mounting

nuts.

6. Installation is the reverse of removal.

QUARTER GLASS MOTOR

1. Remove (-) negative battery terminal.

2. Remove the D pillar trim panel (A). (Refer to the Body group-interior trim)

3. Remove the quarter glass motor (B) after disconnecting the motor connector (A) and quarter glass motor mounting

bolts and screws.

4. Installation is the reverse of removal.

INSPECTION

FRONT POWER WINDOW MOTOR INSPECTION

1. Remove (-) negative battery terminal.

2. Remove the rear door trim panel. (Refer to the Body group-front door)

3. Disconnect the motor connector from the motor.

4. Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next,

reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is
abnormal, replace the motor.

SLIDING POWER WINDOW MOTOR INSPECTION

1. Remove (-) negative battery terminal.

2. Remove the sliding door trim panel. (Refer to the Body group-rear door)

3. Disconnect the motor connector from the motor.

4. Connect the motor terminals directly to battery voltage and check that the motor operates smoothly. Next, reverse

the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal,
replace the motor.

QUARTER GLASS MOTOR INSPECTION

1. Remove (-) negative battery terminal.

2. Remove the D pillar trim panel (A). (Refer to the Body group-interior trim)

3. Disconnect the motor connector from the motor.

4. Connect the motor terminals directly to battery voltage and check that the motor operates smoothly. Next, reverse

the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal,
replace the motor.