Kia Carnival (2009+). Instruction — part 348

6. Remove both sides of the lower arm (A) mounting bolts (B).

7. Remove the engine mounting bolts (A, B)

8. Remove the twelve bolts and nuts of the sub frame by supporting it with a jack.

9. After lowering the jack which supports the sub frame in a proper level, remove both sides of the stabilizer bar

assembly mounting bolts (A).

10. Remove the stabilizer bar assembly through the gap between the body and the rear side of the sub frame.

Be careful not to damage to the power steering related tubes.

11. Remove the brackets (A) and the bushings (B).

INSTALLATION

1. Install the bushing (B) on the stabilizer bar (A).

Bring clamp (C) of stabilizer bar (A) into contact with bushing (B).

2. Install the bracket on the bushing (B).

3. After tightening the bolts of the bushing bracket temporarily, install the bushing bracket on the opposite side.

4. Install the stabilizer bar bracket mounting bolts (A) to the sub frame.

Tightening torque Nm (kgf.m, lb-ft) :
39 ~ 60 (3.9 ~ 6.0, 28.2 ~ 43.4)

5. After lifting the jack which supports the sub frame, install the four bolts (A) of the sub frame and the eight bolts (B)

of the guide bracket.

Tightening torque Nm (kgf.m, lb-ft) :
Bolt (A) : 160 ~ 180 (16 ~ 18, 115.7 ~ 130.2)
Bolt (B) : 45 ~ 60 (4.5 ~ 6.0, 32.5 ~ 43.4)

6. Install the engine mounting bolts (A, B)

Tightening torque Nm (kgf.m, lb-ft) :
65 ~ 85 (6.5 ~ 8.5, 47.0 ~ 61.5)

7. Install both sides of the lower arm (A) mounting bolts(B).

Tightening torque Nm (kgf.m, lb-ft) :
90 ~ 120 (9 ~ 12, 65.1 ~ 86.8)

8. Install both sides of the tie rod end (A) self-locking nuts (B). Insert cooter pin (C) after nut is torqued to

specification.