Kia Carnival (2009+). Instruction — part 329
Restraint
Supplemental Restraint System Control Module
(SRnodeM)- :PKL0TWHJ[:LUZVY:0:
Restraint
2009 > G 2.7 DOHC >
DESCRIPTION
The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and
RH) and two rear SIS which are installed in the rear pillar (LH and RH).
They are remote sensors that detect acceleration due to collision at their mounting locations. The primary purpose of
the Side Impact Sensor (SIS) is to provide an indication of a collision. The Side Impact Sensor (SIS) sends
acceleration data to the SRSCM.
2009 > G 2.7 DOHC >
COMPONENTS
2009 > G 2.7 DOHC >
REMOVAL
FRONT SIDE IMPACT SENSOR
• Removal of the airbag must be performed according to the precautions/procedures described previously.
• Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
• Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact
sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the door scuff trim. (Refer to BD group)
3. Remove the center pillar trim. (Refer to BD group)
4. Disconnect the Side Impact Sensor connector.
5. Remove the SIS mounting bolt then remove the Side Impact Sensor.
REAR SIDE IMPACT SENSOR
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the rear pillar trim. (Refer to BD group)
3. Disconnect the Side Impact Sensor connector.
4. Remove the SIS mounting bolt then remove the Side Impact Sensor.
INSTALLATION
FRONT SIDE IMPACT SENSOR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст