Kia Carnival (2009+). Instruction — part 406

DOOR STRIKER ADJUSTMENT

Make sure the door latches securely without slamming It.
If necessary, adjust the striker (A): The strike nuts Are fixed. The strike can be fine adjusted up or down, and in or out.
striker ceater to be adjusted max ± 1.5mm

1. Loosen the screws (B), then insert a shop towel between the body and striker(A).

2. Lightly tighten the screws.

3. Wrap the striker with a shop towel, then adjust the striker by tapping it with a plastic hammer.

Do not tap the striker too hard.

4. Loosen the screws and remove the shop towel.

5. Lightly tighten the screws.

6. Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door

latches properly, tighten the screws and recheck.

Body (Interior and Exterior)

Exterior - Body Side Moldings

Body (Interior and Exterior)

2009 > G 2.7 DOHC >

REPLACEMENT

ROOF RACK REPLACEMENT

- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the

related parts, to prevent damage.

- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the roof rack cover (A).

2. Remove the roof rack (B), by removing nut protector covers, and removing the nuts.

3. Installation is the reverse of removal.

FRONT MUD GUARD AND WHEEL GUARD REPLACEMENT

- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the

related parts, to prevent damage.

- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the wheel guard (B) first by removing the clip and screw, then remove the wheel guard(A), by removing

the screws and clip.

2. Installation is the reverse of removal.

REAR MUD GUARD AND WHEEL GUARD REPLACEMENT

- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the

related parts, to prevent damage.

- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the wheel guard (B) first by removing the clip and screw, then remove the wheel guard(A), by removing

the screws and clip.

2. Installation is the reverse of removal.

SIDE GARNISH AND SIDE SILL REPLACEMENT