Kia Carnival (2009+). Instruction — part 436
2009 > G 2.7 DOHC >
Replacement
Front Speaker
1. Remove the front door trim panel (Refer to the Body group - front door).
2. Remove the front speaker (A) after removing 4 screw.
3. Installation is the reverse of removal.
Rear Side Speaker
1. Remove the rear seats (Refer to the Body group - Rear seat door).
2. Remove the luggage trim after removing 4 bolts.
3. Remove the rear side speaker(A) (Refer to the Body group - Rear seat).
4. Installation is the reverse of removal.
Tweeter Speaker
1. Remove the tweeter speaker (B) after removing the front filler trim(A) and disconnecting the connector.
2. Installation is the reverse of removal.
Woofer Speaker
1. Remove the rear seats. (Refer to the Body group - rear seats)
2. Remove the luggage side trim (Refer to the Body group - interior trim)
3. Remove the woofer speaker (A) after removing 4 bolts.
4. Installation is the reverse of removal.
External Amplifier
1. Remove the driver seat. (Refer to the Body group - front seats)
2. Remove the external amplifier (A) after removing 3 bolts.
3. Installation is the reverse of removal.
Front Center Speaker
1. Remove the center facia panel.(Refer to the Body group - crash pad)
2. Installation is the reverse of removal.
Inspection
1. Troubleshooting for Speaker
(1) Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring
connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.
(2) Case Troubleshooting
No.
Case
Inspection/Remedy
1
Trembling
sound
1. Before replacing the speaker, inspect that the mounting screw is installed normally.
2. After re-installing the speaker, verify that no trembling sound is heard.
3. When hearing a trembling sound again, replace the speaker with new one.
2
Noise
1. Check if the wiring connector is connected normally. If not, reconnect the wiring
connector.
2. In case of radio static, check if there is a noise from cassette.
3. When a noise is heard on turning radio, cassette and CD on, replace the speaker
with new one.
In case there is only radio static, this causes from poor radio reception. Thus the
speaker needs no repair and replacement.
Inspection of the wiring connection between the battery and the speaker
1. Before replacing the speaker, inspect the wiring connection between the battery and
the speaker is normal.
2. Check the supplying power to the speaker and the resistance, then inspect the
sound quality.
! Specified impedance : 2 ~ 4"
3
Poor working
3. If the speaker works poorly, replace it with new one.
- During dealing of speaker
- Do not damage the speaker with impact as like a drop and a throw.
- Be careful not to cover water and oil over the speaker.
- Caution during dealing of speaker because the material of diaphragm is paper which is easy to be torn
by impact and external force.
- When modifying audio system as customer pleases, this does electric damage to speaker.
- And, in this case the speakers are not covered by the manufacturer's warranty.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст