Kia Carnival (2009+). Instruction — part 393
2009 > G 2.7 DOHC >
SPECIAL TOOLS
Tool (Number and name)
Illustration
Use
09793-21000
Door hinge adjusting wrench
Adjustment, removal and installation
Of the door hinge
09800-21000
Ornament remover
Trim removal
09853-31000
Headliner clip remover
Removal of the headliner clips
09861-31100
Sealant cut-out tool
Cutting the sealant of the windshield
(Use with 09861-31200)
09861-31200
Sealant cutting blade
Cutting the sealant of the windshield
(Use with 09861-31100)
09861-31300
Sealant gun
Application of the sealant to the windshield
09861-31400
Glass holder
Removal and installation of the windshield
09861-31000
Windshield moulding
remover
Removal of the windshield moulding
09880-4F000
Hogring clip installer
Installation of the hogring clip
2009 > G 2.7 DOHC >
TROUBLESHOOTING
Symptom
Suspect Area
Remedy (See page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drain tube
Blow air into drain to remove dirt
Broken or dislocated drain tube, defective
Or cracked clip
Check tube installation and
Flange contact
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and
Improperly fitted weatherstrip
Adjust
Wind noise around sunroof
Loose or deformed deflector, gaps
In body work
Retighten adjust or replace
Sunroof lid makes a noise when
moveing
Foreign particles lodged in guide rail
Check drive cable and guide
Rails for foreign particles
Loose guide rails and lid
Retighten
Motor runs but sunroof does not
move or moves only partially
Foreign particles lodged in guide rail
Check drive cable and guide
Rails for foreign particles
Incorrect engagement of motor pinion
With drive cable
Check for loose motor installation
And damaged pinion
Decrease in motor`s clutch slipping force
Adjust
Increased sunroof sliding resistance
Or interference of sunroof with drive
cables, weatherstrip, etc. due to
maladjustment of sunroof
Adjust or replace
Noise in motor (clutch slipping
Noise from motor when sunroof
Is fully opened or closed is not
An unusual noise
Incorrect engagement of motor pinion
With drive cable
Check pinion installation and
Retighten motor
Worn out or damaged motor pinion bearing
Replace motor assembly
Worn out or deformed drive cable
Replace
Door glass fails to operate
Up and down
Incorrect window glass installation
Adjust position
Damaged or faulty regulator arm or regulator
Correct or replace
Door does not open or close
completely
Incorrect door installation
Adjust position
Defective door check assembly
Correct or replace
Door hinge requires grease
Apply grease
Hood does not open or close
completely
Striker and latch not properly aligned
Adjust
Incorrectly installed hood
Adjust
Incorrect hood bumper height
Adjust
Water leak through windshield
end rear window
Defective seal
Fill with sealant
Defective flange
Correct
Body (Interior and Exterior)
Exterior - Fender
Body (Interior and Exterior)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст