Kia Carnival (2009+). Instruction — part 502

2009 > G 2.7 DOHC >

REMOVAL

1. Remove the windshield wiper arm and blade after removing the mounting nut (A).

TORQUE: 28~32 Nm (2.8~3.2 kgf.m, 20~23.1 lbf.ft)

2. Remove the weather strip and the cowl top cover (A) after removing 4 fasteners.

3. Remove the windshield wiper motor and linkage assembly after removing 4 bolts. Disconnect the wiper motor

connector (A) and windshield deicer connector (B) from the wiper motor & linkage assembly.

Torque: 7-11Nm (0.7-1.1, kgf.m, 5.0-7.9 lbf.ft)

4. Installation is the reverse of removal.

INSTALLATION

1. Install the wiper arm and blade to the specified position.

Specified position

A

B

Distance[in (mm)]

1.57+0.19/0

(40+5/0)

1.57+0.19/0

(40+5/0)

2. Set the washer nozzle on the specified spray position.

INSPECTION

SPEED OPERATION CHECK

1. Remove the connector from the wiper motor.

2. Attach the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1.

3. Check that the motor operates at low speed.

4. Connect the positive (+) lead from the battery to terminal 5 and the negative (-) lead to terminal 1.

5. Check that the motor operates at high speed.

Body Electrical System

Windshield Wiper/Washer - Front Washer

Motor

Body Electrical System

2009 > G 2.7 DOHC >

REPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the front bumper cover. (Refer to Body group - Front bumper)

3. Remove the washer hose, the washer motor connector (A) and washer level sensor connector (C).

4. Remove the washer reservoir after removing 2 bolts and 1 step bolt.

5. Installation is the reverse of removal.

INSPECTION

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

2. Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively.

3. Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. If they

are abnormal, replace the washer motor.