Kia Sedona (2008 year). Instruction — part 250
NO
Substitute with a known-good actuator and check for proper operation. If the problem is corrected,
replace actuator and then go to "VERIFICATION OF VEHICLE REPAIR" procedure.
VERIFICATION OF VEHICLE REPAIR
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
2. Operate the vehicle and monitor the DTC on the scan tool.
3. Are any DTCs present?
YES
Go to the applicable troubleshooting procedure.
NO
System is performing to specification at this time.
DTC B1263 DIRECTION POTENTIOMETER SHORT (HIGH) - REAR
COMPONENT LOCATION
Fig. 136: Identifying Mode Control Actuator Component Location
Courtesy of KIA MOTORS AMERICA, INC.
GENERAL DESCRIPTION
Refer to DTC B1262.
DTC DESCRIPTION
2008 Kia Sedona EX
2008 HVAC Blower & A/C Controls (Automatic) - Sedona
Microsoft
Monday, May 24, 2010 3:56:09 PM
Page 122
© 2006 Mitchell Repair Information Company, LLC.
The A/C controller sets DTC B1263 if there is a short to power in the Direction potentiometer.
DTC DETECTING CONDITION
DTC DETECTING CONDITION CHART
SPECIFICATION
Refer to DTC B1262.
MONITOR SCAN TOOL DATA
1. Connect scan tool to Data Link Connector (DLC).
2. Engine "ON"
3. Monitor the "DR. DIRECTION POTENTIO." parameter on the scan tool while operating mode switch.
Fig. 137: Diagnosis Function Screen Display - Direction Potentiometer Rear
Courtesy of KIA MOTORS AMERICA, INC.
4. Are the DTC B1263 present and is parameter of "DIRECTION POTENTIO." fixed?
Parameter of "DIRECTION POTENTIO." will be fixed at 100% (or any value above 90%), or 0% (or any
value below 10%), if there is any fault in Driver Direction potentiometer.
Item
Detecting Condition
Possible cause
DTC Strategy
Voltage check
Short circuit in harness
Faulty driver direction potentiometer
Open circuit in harness
Threshold value
> 4.9V
Detecting time
0.3 sec
FAIL SAFE
Fix vent position
2008 Kia Sedona EX
2008 HVAC Blower & A/C Controls (Automatic) - Sedona
Microsoft
Monday, May 24, 2010 3:56:09 PM
Page 123
© 2006 Mitchell Repair Information Company, LLC.
YES
Go to TERMINAL AND CONNECTOR INSPECTION procedure.
NO
Fault is intermittent caused by poor contact in the sensor's and/or A/C controller's connector or was
repaired and A/C controller memory was not cleared. Thoroughly check connectors for looseness, poor
connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary
and then go to "VERIFICATION OF VEHICLE REPAIR" procedure.
TERMINAL AND CONNECTOR INSPECTION
Refer to DTC B1262.
SIGNAL CIRCUIT INSPECTION
1. Check for short in harness.
1. Ignition "OFF"
2. Disconnect Rear mode Actuator.
3. Measure resistance between terminal "6" and "7" of Rear Direction potentiometer.
Specification: Approx. infinity ohms
Fig. 138: Checking Resistance Between Terminal "6" And "7" Of Rear Direction
Potentiometer
Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within specifications?
YES
Go to "GROUND CIRCUIT INSPECTION" procedure.
NO
2008 Kia Sedona EX
2008 HVAC Blower & A/C Controls (Automatic) - Sedona
Microsoft
Monday, May 24, 2010 3:56:09 PM
Page 124
© 2006 Mitchell Repair Information Company, LLC.
Check for open in signal harness. Repair as necessary and go to "VERIFICATION OF
VEHICLE REPAIR" procedure.
GROUND CIRCUIT INSPECTION
1. Check for open in ground harness.
1. Ignition "OFF"
2. Disconnect Rear mode Actuator.
3. Measure resistance between terminal "5" of evaporator sensor and chassis ground.
Specification :Approx. 0 ohms
Fig. 139: Checking Resistance Between Terminal "5" Of Evaporator Sensor And Chassis
Ground
Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within specifications?
YES
Go to "COMPONENT INSPECTION" procedure.
NO
Check for open in ground harness. Repair as necessary and go to "VERIFICATION OF
VEHICLE REPAIR" procedure.
COMPONENT INSPECTION
Refer to DTC B1262.
VERIFICATION OF VEHICLE REPAIR
Refer to DTC B1262.
2008 Kia Sedona EX
2008 HVAC Blower & A/C Controls (Automatic) - Sedona
Microsoft
Monday, May 24, 2010 3:56:09 PM
Page 125
© 2006 Mitchell Repair Information Company, LLC.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст