Kia Carnival (2007 year). Instruction — part 303

2007 > 2.7L V6 GASOLINE >

INSPECTION

1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter.

2. Remove the battery and check voltage if the red light doesn't flicker.

Standard voltage : 3V

3. Replace the transmitter battery with a new one, if voltage is below 3V then try to lock and unlock the doors with the

transmitter by pressing the lock or unlock button five or six times.

4. If the doors lock and unlock, the transmitter is O.K, but if the doors don't lock and unlock, register the transmitter

code, then try to lock and unlock the doors.

5. If the transmitter is failure, replace only the transmitter.

Body Control Module

(BCM)

2007 > 2.7L V6 GASOLINE >

DESCRIPTION

All modules are linked a low speed CAN network.
The input information for the modules is coming from both the CAN network and the hardware components
(actuatorsand sensors).

a. FAM (Front Area Module)

a. Headlamp low/high beam control (with DRL)

b. Park lamp control

c. Front fog lamp control

d. Front turn signal lamp control

e. Windshield wiper control

f. Windshield deicer

g. Diagnostics

b. IPM (In-Panel Module)

a. RKE (Remote Keyless Control)

b. VAS (Voice Alarm System)

c. Ignition key hole illumination

d. Switch indicators control

e. Panel light control

f. Seat belt warning

g. Auto light/DRL control (Logic)

h. Windshield/Rear wiper control (Logic)

i. Turn and Hazard lamp control (Logic)

j. Central door lock (Logic)

k. Windshield deicer timer

l. Rear glass defog timer

m. Gateway for ISO-9141 (K-Line)

c. RAM (Rear Area Module)

a. Tail lamp control

b. Turn and Hazard lamp control

c. Back up lamp control

d. Rea fog lamp control

e. Stop lamp outage detection

f. Sliding door power window/Quarter glass control

g. Room lamp control

h. Rear wiper control

i. Rear glass defog

j. Fuel filler door open solenoid control

d. ADM (Assist Drive Module)

e. DDM (Driver Drive Module)

MODULE INTRODUCTION

FAM/IPM/RAM consists of a power board and an electronic board. The power board contains circuit protection devices
and switching devices. The electronic board uses Intelligent Power Switching (IPS) for HS/LS load control, logic
functions and CAN/K-Line communication. The power board and electronic board are connected with pin blocks for
the Front Area Module (FAM) and VCD (Variable Connection Displacement) for the In-Panel Module (IPM) and the
Rear Area Module (RAM).

Functions

Exterior Lighting Functions

The exterior lighting function has to provide the lighting and signalling of the vehicle; it monitors different available
lights in front or at the back of the vehicle:

a. Park and Tail lamps (with Side marker lamps),

b. License plate lamps,

c. Head lamps Low Beam,

d. Head lamps High Beam,

e. Front and Rear fog lamps (with the Rear fog lamp switch indicator),

f. Stop lamps,

g. Backup lamps,

h. Turn signal and side repeater lamps.

Park/tail Lamps Function

1. Necessary conditions to switch ON :

a. By putting the Head lamp switch in position 'Park and Tail lamp' or 'Head lamp Low Beam' or Auto light

activation or DRL activation

2. Necessary conditions to switch OFF :

a. If they are released by the Head lamp switch (Auto light function deactivated) and if DRL function is deactivated

b. If the Auto light function is active but the Auto light Sensor signal status is OFF or Battery Saver function is

active.

3. Functional diagram