Kia Carnival (2007 year). Instruction — part 109

30. Remove the starter motor cover(A).

31. Disconnect the starter motor connector and remove the starter motor(A). (see EE group)

32. Remove the mounting bolts(A) of lower part of the transaxle, and remove the transaxle assembly by supporting it

with a jack.

INSTALLATION

1. Lowering the vehicle or lifting up a jack, install the transaxle assembly.

2. Tighten the transaxle under mounting bolts.

TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)

3. Install the starter motor(A) and connect the starter motor connector. (see EE group)

TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)

4. install the starter motor cover(A).

5. install the side cover(A).

6. Install the drive shafts(A) to the transaxle. (see DS group)

7. Install the inner shaft bracket mounting bolt(A). (see DS group)

8. Install the exhaust pipe(A).

TORQUE:
39.2~58.8Nm(4.0~6.0kgf.m, 28.9~43.4lb-ft)

9. Install the sub frame(A). (see SS group)

TORQUE:
60~80Nm(6.0~8.0kgf.m, 65.1~79.5lb-ft)

10. Connect the vrs connector(A). (see ST group)

11. Install the rear roll stopper mounting bolts(A).