Kia Carnival (2007 year). Instruction — part 525

5. Tighten the clutch cover.

TORQUE:
24.5~35.3Nm (250~360kgf.cm, 18.1~26.0lb-ft) (6EA)

When installing the clutch cover, tighten the bolts in diagonal directions not to be bent or twisted.

* Possible problems when not following

a. When tightening the bolt completely at a time: the clutch cover can be twisted and vibration can occur.
b. On vehicles with self adjusting clutches, it is necessary to follow this caution.
c. Not following tightening torque: There can be bad torque transmission in clutch and relaxation possibility of

bolts.

INSPECTION

1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing.

2. Check the clutch cover and disc surface for wear or crack.

3. Check the clutch disc lining for slipping or oil mark.

4. Measure the depth from a clutch lining surface to a rivet. If the measured value is less than the specification below,

replace it.

Specification: 0.3mm(0.0118inch)

Clutch Master Cylinder

2007 > J2.9L DIESEL CRDI(VGT) >

REMOVAL

Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off
immediately with water.

1. Remove the brake fluid fron the clutch master cylinder reservoir with a syringe.

2. Clamp the clutch master cylinder hose(A). If there is no enough room for clamping, you can also clamp the hose

from the brake master cylinder side.

3. Disconnect the hose(A) from the cylinder by releasing the clutch master cylinder clamp.

4. Remove the clutch master cylinder mounting bolts(A,B).

One is the engine room, the other near the clutch pedal assembly.