Kia Carnival (2007 year). Instruction — part 212

2007 > 2.7L V6 GASOLINE >

components

2007 > 2.7L V6 GASOLINE >

removal

1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2. Remove the following parts. (Refer to BD group)

a. Interior trim

b. Headlining

3. Disconnect the Curtain Airbag harness connector (front & rear).

4. After loosening the mounting bolts (13EA), remove the curtain airbag.

INSTALLATION

a. Be sure to install the harness wires not to be pinched or interfered with other parts.

1. Disconnect the negative (-) cable from battery and wait for at least three minutes.

2. Remove ignition key from the vehicle.

3. Install a Curtain Airbag (CAB) on the mounting bracket.

4. Tighten the CAB mounting bolts (13EA).

Tightening Torque (CAB Mounting Bolt)
: 1.9 ~ 2.7 kgf.m(18.6 ~ 26.5 Nm, 13.7 ~ 19.5 lb.ft)

a. Never twist the airbag module when installing it. If the module is twisted, airbag module may operate

abnormally.

5. Connect the CAB connector (front & rear).

6. Reconnect the battery negative cable.

7. After installing the Curtain Airbag (CAB), confirm proper system operation:

a. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module

2007 > 2.7L V6 GASOLINE >

DESCRIPTION

The two Side Airbags (SAB) are installed inside the driver and passenger seat and protects the driver and front
passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Side
Impact Sensor (SIS) signal.

Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious
personal injury.