Kia Carnival (2007 year). Instruction — part 206
2007 > 2.7L V6 GASOLINE >
DESCRIPTION
The front impact sensors (FIS) are installed in the side member. They are remote sensors that detect acceleration due
to a collision at their mounting locations. The primary purpose of the Front Impact Sensor (FIS) is to provide an
indication of a collision. The Front Impact Sensor(FIS) sends acceleration data to the SRSCM.
2007 > 2.7L V6 GASOLINE >
COMPONENTS
2007 > 2.7L V6 GASOLINE >
removal
a. Removal of the airbag must be performed according to the precautions/ procedures described previously.
b. Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
c. Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact
sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Disconnect Front Impact Sensor conncetor.
3. Remove the FIS mounting bolt then remove the Front Impact Sensor.
INSTALLATION
a. Ensure that the harness is installed and routed properly to prevent damage to the wiring.
b. Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact
sensor.
1. Install the new Front Impact Sensor with bolt then connect the SRS harness connector to the Front Impact Sensor.
Tightening torque
: 1.0 ~ 1.4 kgf.m (9.5 ~ 13.6 Nm, 7.0 ~ 10.0 lb.ft)
2. Reconnect the negative battery cable.
3. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS
indicator light should be turned on for about six seconds and then go off.
Side Impact Sensor
(SIS)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст