Kia Carnival (2007 year). Instruction — part 226

10. After installation, check for leaks at hose and line joints or connections, and retighten if necessary.

INSPECTION

FRONT BRAKE DISC THICKNESS CHECK

1. Remove all rust and contramination from the surface, and measure the disc thickness at 8 points, at least, of same

distance (5mm) front the brake disc outer circle.

Front brake disc thickness
Standard value : 28 mm(1.10 in)
Limit : 26 mm(1.02 in)

2. Thickness variation should not exceed 0.005mm (0.0002 in) (circumference) and 0.01 mm (0.0004 in)(radius) at

any directions.

3. If wear exceeds the limit, replace the discs and pad assemblies on the left and right sides of the vehicle.

FRONT BRAKE PAD CHECK

1. Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.

Pad thickness
Standard value : 11 mm (0.43 in)
Service limit : 2 mm (0.0787 in)

2. Check that grease is applied, to sliding contact points and the pad and backing metal for damage.

FRONT BRAKE DISC RUN OUT CHECK

1. Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the run out of

the disc.

Brake disc run out
Limit : 0.03 mm (0.0012 in.) or less (new one)

2. If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out

again.

3. If the run out does not exceed the limit specification, install the brake disc after turning it 180° and then check the

run out of the brake disc again.

4. If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.

Seizing of Front brake disc

1. Remove the brake disc from hub using an M8 screw(A) if the brake disc has been seized with the hub due to

corrosion or overheating.

Be careful not to use a hammer. The disc can be damaged if you remove the disc from the hub by
hammering.

Rear Disc Brake

2007 > 2.7L V6 GASOLINE >

COMPONENTS