Kia Carnival (2007 year). Instruction — part 518

2007 > J2.9L DIESEL CRDI(VGT) >

REMOVAL

a. Use a cover not to damage the vehicle surface.
b. Disconnect connectors carefully not to be damaged.

a. Mark wires or hoses for identification not to be confused.

1. Remove the battery (A).

2. Disconnect the AFS connector (A).

3. Remove the air cleaner upper cover (B) by loosening the clips (A).

4. Remove the air cleaner assembly (A) by removing the two mounting bolts.

5. Disconnect the air cleaner hose (B) by loosening the clamp (A).

6. Remove the battery tray (B) by removing the four mounting bolts (A).

7. Remove the ground wire (A) from the transaxle case.

8. Remove the vehicle speed sensor connector (A).

9. Remove the shift cable by removing the bolt (A) and clip (B).

10. Disconnect the "N" (A) and the "R" (B) position switch.

11. Remove C.S.C (Concentric Slave Cylinder) tube which is being clamped.

12. Remove the CKP sensor from the clutch housing assembly.

13. Remove the mounting bolts of upper part of the transaxle.

14. Support the engine and transaxle by using the special tool (09200-38001).

15. Remove the transaxle insulator (B) and the bracket (C) by removing the bolts (A).

16. Remove the front wheels and tires. (see SS group)

17. Remove the steering column joint bolt. (see ST group)

18. Lift up the vehicle.

19. Remove the under cover.

20. Drain power steering oil through the return tube. (see ST group)

21. Disconnect the power steering pressure hose (A) from the power steering oil pump.

22. Disconnect the lower arm, the tie rod end ball joint, the stabilizer bar link from the front knuckle. (see SS group)

23. Remove the roll stopper mounting bolts.

24. Remove the mounting bolts from the sub frame by supporting the sub frame with a jack. (see SS group)

25. Remove the drive shafts from the transaxle. (see DS group)

26. Remove the plate between the engine and transaxle.

27. Disconnect the starter motor connector and remove the starter motor. (see EE group)

28. Remove the mounting bolts of lower part of the transaxle, brackets (A,B), and the left side cover and remove the

transaxle assembly by supporting it with a jack.