Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1726
FRONT SUSPENSION
3C–5
Cupped Tires
Worn hab unit bearings.
Replace hab unit bearing.
Excessive tire or wheel run out.
Replace tire or wheel.
Worn ball joints.
Replace ball joints.
Tire out of balance.
Adjust tire balance.
Condition
Possible cause
Correction
3C–6
FRONT SUSPENSION
Shock Absorber
Shock Absorber and Associated Parts
450RW009
EndOFCallout
Removal
1. Raise the vehicle and support it with suitable safety
stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove bolt and nut.
4. Remove nut.
5. Remove rubber bushing and washer.
6. Remove shock absorber.
7. Remove rubber bushing and washer.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts :
• Shock absorber
• Rubber bushing
Installation
1. Install rubber bushing and washer.
2. Install shock absorber.
3. Install rubber bushing and washer.
4. Install nut, then tighten it to the specified torque.
Torque: 20 N·m (14 lb ft)
5. Install bolt and nut, then tighten to the specified
torque.
Torque: 93 N·m (69 lb ft)
Legend
(1) Nut
(2) Rubber Bushing and Washer
(3) Bolt and Nut
(4) Shock Absorber
(5) Rubber Bushing and Washer
FRONT SUSPENSION
3C–7
Stabilizer Bar
Stabilizer Bar and Associated Parts
410R100001
EndOFCallout
Removal
1. Raise the vehicle and support the frame with
suitable safety stands.
2. Remove the stone guard.
3. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
4. Remove nut (4) and (6).
CAUTION: Be careful not to break the ball joint
boot.
5. Remove link.
6. Remove bracket.
7. Remove stabilizer bar.
8. Remove rubber bushing.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts :
• Stabilizer bar
• Rubber bushing
• Link ball joint
Installation
1. Install rubber bushing.
2. Install stabilizer bar.
3. Install bracket and bolt, then tighten it to the
specified torque.
Torque: 25 N·m (18 lb ft)
4. Install link.
5. Install nut (4),(6) and washer, then tighten it to the
specified torque.
Torque: 50 N·m (37 lb ft)
Legend
(1) Rubber Bushing
(2) Bracket and Bolt
(3) Link
(4) Nut
(5) Stabilizer Bar
(6) Nut and Washer
3C–8
FRONT SUSPENSION
Torsion Bar
Torsion Bar and Associated Parts
410RS003
EndOFCallout
Removal
1. Raise the vehicle and support the frame with
suitable safety stands.
2. Apply the setting marks(1) to the adjust bolt and end
piece, then remove adjust bolt, end piece and seat.
410RS004
Legend
(1) Adjust Bolt, End Piece and Seat
(2) Height Control Arm
(3) Torsion Bar
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст