Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 918
7A–98
AUTOMATIC TRANSMISSION (4L30–E)
2. Install extension housing assembly (3) to the
transmission. Tighten extension housing assembly
bolts as shown in the figure.
261RY00001
3. Install speedometer driven gear bushing and driver
gear.
4. Connect harness connectors and fuel pipe fix bolt.
Connector: speed sensor.
5. Install propeller shaft (1) and mass (2).
Torque: 63 N·m (46 lb ft)
6. Fill extension housing assembly fluid.
7. Connect battery ground cable.
7A–99
AUTOMATIC TRANSMISSION (4L30–E)
Extension Housing Assembly
Extension Housing Assembly and Associated Parts
220RY00009
Legend
(1) Speedometer Sensor, Speedometer Driven
Gear and Plate
(2) Companion Flange
(3) Extension Housing Assembly
7A–100
AUTOMATIC TRANSMISSION (4L30–E)
Removal
1. Remove the speedometer sensor (1).
2. Remove the plate (1).
3. Remove the speedometer driven gear bushing and
driven gear (1).
NOTE: Apply a reference mark to the driven gear bushing
before removal.
4. Remove rear companion flange (2), using the flange
companion holder J–8614–11 to remove the end nut.
266RW001
5. Remove the rear companion flange.
NOTE: Use the universal puller to remove the rear
companion flange.
Installation
1. Install companion flange (2), using the companion
flange holder J–8614–11 to tighten the flange nuts to
the transfer case.
266RW001
2. Tighten the new transfer flange nuts to the specified
torque.
Torque
Companion flange: 167 N·m (123 lb ft)
3. Use the punch J–39209 to stake the companion
flange nut (3) at two spots.
266RS001
266RW002
7A–101
AUTOMATIC TRANSMISSION (4L30–E)
NOTE: Be sure to confirm that there is no crack at the
staked portion of the flange nut after staking.
4. Install the O–ring (7) to the speedometer driven gear
bushing (6).
5. Install the driven gear to the speedometer driven gear
bushing (6).
6. Install the speedometer driven gear assembly to the
extension housing assembly.
7. Install the plate (5) to the extension housing assembly
and tighten to the specified torque.
Torque: 15 N·m (11 lb ft)
8. Install the speedometer sensor and tighten to the
specified torque.
Torque: 27 N·m (20 lb ft)
225RY00003
Legend
(4) Bolt
(5) Plate
(6) Bushing
(7) O–ring
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст