Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1000
8F–50
BODY STRUCTURE
5. Remove door harness connection (3).
D
Pull the door harness grommet out in order to
disconnect the door harness connection.
810RS002
6. Remove door assembly
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Align the door fitting to the body by refer to Body
Dimensions in this section.
2. Tighten the door hinge bolts to the specified torque.
Torque : 34 N
•
m (25 lb ft)
3. Apply chassis grease to the check arm pin and the
door hinge moving surface.
Door Strikers
Adjustment
632RS001
1. Loosen the striker (1) screws.
2. Tap with a plastic hammer to align.
3. Tighten the striker screws.
Torque : 15 N
•
m (11 lb ft)
8F–51
BODY STRUCTURE
Door Check Arm Assembly (Front & Rear)
Parts Location
630RS003
Legend
(1) Front or Rear Door
(2) Door Trim Panel
(3) Check Arm Assembly
(4) Check Arm Pin Bracket
(5) Check Arm Pin
(6) Front or Center Pillar
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
D
Refer to Front / Rear Door Trim Panel in Exterior /
Interior Trim section.
3. Remove check arm pin (1).
630RS002
8F–52
BODY STRUCTURE
4. Remove check arm assembly.
D
Carefully peel off the water proof sheet as much as
necessary, for check arm removal.
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. When installing the check arm assembly, note its
marking to ensure using the appropriate part.
2. Tighten the check arm fixing nuts to the specified
torque.
Torque : 13 N
•
m (113 lb in)
3. Apply chassis grease to the check arm pin moving
surface.
Front Window Regulator, Glass And Glass Run
Parts Location
631RS002
Legend
(1) Speaker Box
(2) Glass Run
(3) Glass
(4) Rear Guide Rail
(5) Window Regulator
(6) Window Regulator with Power Window
(7) Window Regulator Motor Connector
(8) Door Trim Panel
(9) Waterproof Sheet
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
D
Refer to Front Door Trim Panel in Exterior / Interior
Trim section.
3. Remove speaker box.
8F–53
BODY STRUCTURE
4. Remove waterproof sheet.
631RS003
D
Take notice of the door harness and the grommet,
peel the waterproof sheet off the door panel
carefully.
5. Remove glass.
D
Bring the glass (1) down to the position where the
fixing bolts can be seen.
631RS004
D
Remove the glass fixing bolts from the window
regulator (2) and lower thefront side of the glass.
When the front side of the glass comes off the glass
run (3), turn the glass inside out and pull it up from its
rear side.
631RS005
6. Remove window regulator.
D
Remove the window regulator fixing bolts (4) and
the rear guide rail fixing bolt (5).
D
Disconnect the window regulator motor harness
connector, if equipped with power windows.
631RS006
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст