Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 468
METER AND GAUGE
8E–3
Rear View
821R200018
Legend
(1)
Illumination Light Bulb
(2)
Illumination Light Bulb
(3)
Illumination Light Bulb
(4)
Illumination Light Bulb
8E–4
METER AND GAUGE
Table for Meter/Gauge Connector Terminal Connections
821RY00053
Legend
(1)
Connector A
(2)
Connector B
(3)
Connector C
METER AND GAUGE
8E–5
Connector A
Terminal
Function
1
—
2
Intelligent suspension indicator light
3
TOD indicator light “Rear”
4
—
5
TOD indicator light “AUTO”
6
—
7
TOD indicator light “Front”
8
A/T shift indicator light “3”
9
A/T shift indicator light “D”
10
A/T shift indicator light “2”
11
SRS – air bag warning light
12
Ground
13
Battery
14
Stater switch
15
A/T oil temperature warning light
16
Seat belt indicator light
17
Charge warning light
18
—
19
—
20
—
21
A/T shift indicator light “L”
22
ABS warning light
23
—
24
—
25
Reduced power warning light
26
Oil pressure warning light
27
Check trans warning light
28
MIL(check engine) warning light
29
Check TOD
30
Engine coolant temperature gauge
Connector B
Terminal
Function
1
A/T shift indicator light “R”
2
A/T shift indicator light
3
A/T shift indicator light “N”
4
A/T shift indicator light “P”
5
Illumination light
6
Engine revolution pulse
7
Speed sensor pulse
8
Turn signal indicator light (LH)
9
Brake warning light
10
High beam indicator light (+)
11
High beam indicator light (–)
12
Turn signal indicator light (RH)
13
Turn signal indicator light
14
—
15
Illumination light
16
Ground
Connector C
Terminal
Function
1
Starter switch
2
—
3
Fuel gauge
4
Low fuel warning light
5
Cruise set indicator light
6
—
7
—
8
—
9
—
10
Sport mode indicator light
11
—
12
Winter drive indicator light
13
Power drive indicator light
14
—
8E–6
METER AND GAUGE
Removal
1. Disconnect the battery ground cable.
2. Remove the Dash Side Trim Panel –LH.
3. Remove the lower cover Assembly(2).
D
Refer to
Instrument Panel Assembly in Body
Structure section.
4. Remove the meter cluster Assembly(1).
D
Refer to
Instrument Panel Assembly in Body
Structure section.
821R200020
5. Remove the meter assembly(3).
D
Remove four fixing screws.
D
Disconnect the meter connectors.
825RW197
CAUTION: The removed meter assembly should be
placed upright or with its face side up.
Installation
To install, follow the removal steps in the reverse order.
Warning Light Bulb and Indicator Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the meter assembly.
D
Refer to
Meter Assembly in this section.
3. Remove the bulb.
D
Hold the bulb socket by hand, rotate it
counterclockwise and pull it out.
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст