Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1176
BRAKE CONTROL SYSTEM
5A–33
Chart A-3, TA-3 The Wheels Are Locked
Chart A-4 Brake Pedal Feed Is Abnormal
Step
Action
Yes
No
1
Is ABS working?
Go to Step 2
Go to Step 4
2
Is vehicle speed under 10 km/h (6mph)?
Go to Step 3
Normal.
3
Is sensor output normal? (Chart C-1 or TC-1)
Go to Step 4
Replace sensor
or repair
harness.
Go to Step 6
4
Is front 4WD controller normal?
Go to Step 5
Replace 4WD
controller or
repair harness.
Go to Step 6
5
Is hydraulic unit grounded properly?
Replace EHCU.
Go to Step 6
Repair.
Go to Step 6
6
Reconnect all components, ensure all components are properly
mounted.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart”
Go to Step 6
Step
Action
Yes
No
1
Is the stop light actuated when the brake pedal is depressed?
Go to Step 2
Go to Step 3
2
1. Turn the ignition switch off.
2. Disconnected EHCU connector.
Is the check voltage EHCU connector terminals 13 to 7 when
brake pedal is depressed than battery voltage?
Go to Step 4
Harness NG
between brake
SW and EHCU.
Go to Step 6
3
Is stop light fuse normal?
Go to Step 5
Replace stop
light fuse.
Go to Step 6
4
Is the check continuity between EHCU connector terminals, 7 to
body grounded?
Go to Step 6
Repair body
grounded
harness.
Go to Step 6
5
Is brake SW normal?
Repair stop
light harness.
Go to Step 6
Replace brake
SW.
Go to Step 6
6
Reconnect all components, ensure all components are properly
mounted.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart”
Go to Step 6
5A–34
BRAKE CONTROL SYSTEM
Chart A-5, TA-5 Braking Sound (From EHCU) Is Heard While Not Braking
Step
Action
Yes
No
1
Is this the first vehicle start after engine start?
Normal.
(It is self
checking
sound.)
Go to Step 2
2
Is vehicle speed under 10 km/h (6 mph)?
Normal.
(It is self
checking
sound.)
Go to Step 3
3
Check for the following condition:
• At the time of shift down or clutch operation.
• At the time of low road friction drive (ice or snow road) or rough
road drive.
• At the time of high-speed turn.
• At the time of passing curb.
• At the time of operating electrical equipment switches.
• At the time of racing the engine (over 5000 rpm).
Did it occur under any one condition above?
ABS may
sometimes be
actuated even
when brake pedal
is not applied.
Go to Step 4
4
Is there play in each or any sensor/wheel speed sensor rings?
Repair.
Go to Step 7
Go to Step 5
5
Damage or powdered iron sticking to each or any sensor/wheel
speed sensor ring?
Repair.
Go to Step 7
Go to Step 6
6
Is each sensor output normal? (Refer to chart C-1 or TC-1).
Check harness/
connector for
suspected
disconnection
If no
disconnection is
found, replace
Coil integrated
module.
Go to Step 7
Repair.
Go to Step 7
7
Reconnect all components, ensure all components are properly
mounted.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart”
Go to Step 7
BRAKE CONTROL SYSTEM
5A–35
Diagnostic Trouble Codes
Choose and trace an appropriate flowchart by the
numbers listed below to find fault and repair.
Code
Diagnosis
Item
Chart
No.
Flash out
Serial
Communications
12
—
—
—
—
13
C0285
2 WD Controller in 4WD Vehicle Controller
Wiring
B-8
14
C0271
RAM read/write error
Coil Integrated
Module
B-2
C0272
ROM checksum error
C0270
ALU function error
C0273
Inoperative isolation item
C0284
Loop time overrun
15
C0277
Low ignition voltage
Wiring
B-3
C0278
High ignition voltage
17
C0269
Excessive dump time
Coil Integrated
Module
B-4
18
C0274
Excessive isolation time
B-5
21
C0276
G-Sensor Failure
B-6
22
C0281
Brake switch Failure
B-7
24
C0282
Open or shorted 4
´4 input signal (4WD only)
Wiring
B-8
32
C0267
Open motor circuit or shorted ECU output
Motor
B-9
C0268
Stalled motor or open ECU output
35
C0265
Open relay circuit
Relay
B-10
C0266
Shorted relay circuit
41
C0245
FL Open isolation solenoid or shorted ECU output
Solenoid
B-11
C0247
FL Shorted isolation solenoid or open ECU output
42
C0246
FL Open dump solenoid or shorted ECU output
B-12
C0248
FL Shorted dump solenoid or open ECU output
43
C0241
FR Open isolation solenoid or shorted ECU output
B-13
C0243
FR Shorted isolation solenoid or open ECU output
44
C0242
FR Open dump solenoid or shorted ECU output
B-14
C0244
FR Shorted dump solenoid or open ECU output
45
C0251
Rear Open isolation solenoid or shorted ECU output
B-15
C0253
Rear Shorted isolation solenoid or open ECU output
46
C0252
Rear Open dump solenoid or shorted ECU output
B-16
C0254
Rear Shorted dump solenoid or open ECU output
5A–36
BRAKE CONTROL SYSTEM
51
C0225
FL Open or shorted sensor
Sensor or
Wiring
B-17
52
C0221
FR Open or shorted sensor
B-18
53
C0235
Rear Open or shorted sensor
B-19
61
C0226
FL Missing sensor signal
B-20
C0227
FL Sensor signal dropout
62
C0222
FR Missing sensor signal
B-21
C0223
FR Sensor signal dropout
63
C0236
Rear Missing sensor signal
B-22
C0237
Rear Sensor signal dropout
64
C0229
Simultaneous dropout of front sensor signal
B-23
65
C0238
Wheel speed error
Vehicle or
Sensor
B-24
—
C0286
Shorted indicator lamp
Wiring
—
Code
Diagnosis
Item
Chart
No.
Flash out
Serial
Communications
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст