Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 78
INTELLIGENT SUSPENSION
3F–33
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly.
Refer to
Consoles in Body and Accessories section.
3. Disconnect the connector from the control unit.
View A
828RY00002
Legend
(1) Nut
(2) Screw
(3) Control Unit
(4) Bracket
4. Remove 4 nuts.
5. Disconnect the control unit with brackets.
6. Remove 4 screws.
7. Disconnect the control unit from brackets.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
Torque:
Nut (1) 8N·m (69 lb in)
3F–34
INTELLIGENT SUSPENSION
Front Actuator
Front Actuator and Associated Parts
RH
450RY00004
Legend
(1) Connector
(2) Clip
(3) Actuator
(4) Shock Absorber
(5) Front
(6) Bracket
LH
450RY00003
Legend
(1) Connector
(2) Clip
(3) Actuator
(4) Shock Absorber
(5) Front
(6) Bracket
INTELLIGENT SUSPENSION
3F–35
Removal
1. Disconnect the battery ground cable.
2. Disconnect the connector from the harness and
remove the connector from the bracket.
3. Remove the clip.
View B
450RY00005
Legend
(1) Screw
(2) Actuator
(3) Nut
(4) Bracket
(5) Nut
(6) Washer
(7) Shock Absorber
1. Remove 2 screws.
2. Remove the actuator.
3. Remove the nut (3).
4. Disconnect bracket.
5. Remove the nut (5).
6. Disconnect the washer.
7. Remove the shock absorber.
Refer to
Shock Absorber in this section.
Inspection and Repair
Refer to
shock Abosorber in this section.
Installation
1. Install the shock absorber.
Refer to
Shock Absorber in this section.
2. Install the washer and nut (5), then tighten it to the
specified torque.
Torque: 15 N·m (11 lb ft)
3. Install the bracket and nut (3), then tighten it to the
specified torque.
Torque: 39 N·m (29 lb ft)
NOTE: Fix the lower nut with wrench not to turn and
tighten upper nut.
4. Fit the top of the shock absorber rod in the connection
part of the actuator.
NOTE:
The mating section is width fitting across flats.
If these normally fit, the distance between the
actuator lower face and the bracket upper face is
about 1 mm.
5. Install 2 screws then tighten it to the specified torque.
3 N·m (26 lb in)
6. Connect the connector to the harness and insert the
connector to the bracket.
7. Connect the actuator harness with the clip.
8. Connect the battery ground cable.
3F–36
INTELLIGENT SUSPENSION
Rear Shock Absorber
Rear Shock Absorber and Associated Parts
LH
461R100003
Legend
(1) Connector
(2) Clip
(3) Rear Shock Absorber
(4) Bracket
(5) Bolt
(6) G-Sensor
(7) Front
(8) Upper
(9) Right
(10) Connector
(11) Gusset
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст