Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1144
DRIVELINE CONTROL SYSTEM
4B–9
Wiring Diagram
D04R200028
4B–10
DRIVELINE CONTROL SYSTEM
D04R200027
DRIVELINE CONTROL SYSTEM
4B–11
Connector List
No.
Connector face
B-8
B-19
C-16
C-36
C-47
C-49
E-30
E-56
E-57
E-60
H-6
H-15
H-17
H-18
I-1
I-19
No.
Connector face
4B–12
DRIVELINE CONTROL SYSTEM
Diagnosis of The Faults Based on the
Status of 4WD Indicator Lamp, 4WD Switch
and T/F Change Lever
A diagnostic flow chart is shown below. If after
performing the diagnosis and a condition still exists,
then there may be a fault in the ECU. The ECU will
need to be replaced and perform the diagnostic flow
chart again.
Fault on Switching from 2WD to 4WD
1. When the 4WD indicator lamp blinking pattern
changes (from 2Hz to 4Hz) after performing
“Solution 1.”
The motor actuator or the transfer case assembly
may be inoperative. Remove the motor actuator
and perform bench test. Make any needed repairs
and perform “Solution 1” again. Then disassemble
and inspect the transfer case assembly. Repair or
replace as needed. If after the repairs, the
condition still exists, then replace the ECU.
2. When the 4WD indicator lamp do not blink or
light up when switching from 2WD to 4WD.
Step
Action
Yes
No
1
Is ignition turned on?
Go to Step 2
Turn on the ignition
and trace this chart
from start.
2
Does the 4WD indicator lamp light up during the two second
initialization after the ignition is turned on?
Go to Step 3
Burned out
indicator lamp or
disconnected
harness wire.
Perform the
diagnostic chart
from step 1 after
repair or
replacement.
3
Is the 4WD switch activated from 2WD to 4WD mode?
Short-circuit
(body short) on
harness of the
4WD switch.
Inoperative
4WD switch
(stuck closed
condition).
Trace this chart
from the step 1
after repair or
replace.
Push the 4WD
switch to 4WD.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст