Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 131
4C–24
DRIVE SHAFT SYSTEM
2. Install a new needle bearing into inner shaft by using a
Installer J–41694 and grip J–8092.
412RS051
3. Place a new snap ring(internal) in inner shaft.
Install a new inner shaft bearing into the inner shaft.
412RS044
4. Install snap ring(external).
NOTE: Be careful not to damage the inner shaft.
5. Clean the housing contact surface of the front axle
case and insert inner shaft assembly into the front
axle case.
NOTE: Be careful not to damage seal.
6. Install snap ring internal in the groove of front axle
case.
NOTE: Be sure to install the snap ring properly.
412RW017
7. Apply differential gear oil to clutch gear, then install
clutch gear.
8. Apply differential gear oil to sleeve, then install
sleeve.
9. Clean contact surface with the front axle and actuator
mounting surface. Apply liquid gasket to the contact
surface on the front axle case, then install in the
housing.
412RW023
10. Tighten bolts to specified torque.
Torque: 75N·m(55 lb ft)
11. Clean the actuator contact surface with the housing
then Install and tighten shift position switch to
specified torque.
Torque: 39N·m (29 lb ft)
4C–25
DRIVE SHAFT SYSTEM
12. Apply liquid gasket to the contact surface on the
actuator side.
412RW012
13. Align shift arm with the groove of sleeve and install the
actuator.
14. Tighten bolts to specified torque.
Torque: 9N·m(78 lb in)
15. Install front axle drive shaft and mounting bracket.
Tighten fitting bolts to specified torque.
Torque: 116N·m (85 lb ft)
16. Pour specified amount of differential gear oil to filler
plug.
Front Differential
Oil Capacity: 1.4lit (1.48US qt)
Actuator Housing
Oil Capacity: 0.12lit(0.13US qt)
17. Install filler plug through gasket and tighten to
specified torque.
Torque: 78N·m (58lb ft)
4C–26
DRIVE SHAFT SYSTEM
Main Data and Specifications
General Specifications
Front drive axle oil capacity
1.25 liter (1.32 US qt)(Differential)
0.12 liter (0.13 US qt)(Actuator Housing:Shift on the fly)
Type of lubricant
GL–5 (75W–90) Refer to
chart in General Information
Axle shaft type
Constant velocity joint(Birfield joint type and double offset joint)
Torque Specifications
412RY00040
4C–27
DRIVE SHAFT SYSTEM
E04RW001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст