Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 947
MANUAL TRANSMISSION
7B–23
15. Remove the thrust washer.
1. Remove the thrust washer from counter gear
shaft.
2. Remove the thrust washer pin from counter gear
shaft.
226RW018
16. Remove the bearing plate.
1. Remove the 4 bolts and bearing retainer.
226RW016
17. Remove the reverse idle gear.
1. Pull out the shaft foward the rear and remove the
reverse idle gear.
226RW020
18. Remove the counter gear shaft.
1. Using snap ring plier, remove counter gear shaft
center bearing snap ring.
226RW015
7B–24 MANUAL TRANSMISSION
2. Using remover J–42795 and attachment
J–42988, remove counter gear shaft center
bearing.
NOTE: Be careful not to drop the counter gear, when
removing the bearing.
226RW036
3. Remove the counter gear from intermediate
plate.
226RW030
19. Disassemble the counter gear shaft assembly.
1. Using snap ring pliers, remove the counter gear
shaft front bearing snap ring.
226RW065
2. Using bearing separator J–22912–01 and a
press, remove the bearing.
226RW068
MANUAL TRANSMISSION
7B–25
20. Remove the top gear shaft.
1. Remove the top gear shaft from mainshaft.
NOTE: Don’t fall needle roller bearing.
226RW029
2. Remove the 4th block ring and roller bearing.
226RW031
21. Disassemble the top gear shaft assembly.
1. Check for wear or damage.
226RW033
2. Remove the front bearing shaft snap ring.
226RW062
7B–26 MANUAL TRANSMISSION
3. Using bearing separator J–22912–01 and a
press, remove the bearing.
226RW069
22. Remove the mainshaft.
1. Remove mainshaft bearing snap ring.
226RW035
2. Using a plastic hammer, tap the 5th-reverse shift
rod at the reverse shift side.
226RW034
3. Remove the intermediate plate from a vise.
4. Remove the mainshaft, 1st-2nd shift arm and
3rd-4th shift arm.
226RW014
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст