Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 651
4C–30
DRIVE SHAFT SYSTEM
6. Install snap ring (internal) in the groove of front axle
case.
NOTE: Be sure to install the snap ring properly.
412RW017
7. Apply differential gear oil to clutch gear, then install
clutch gear.
8. Apply differential gear oil to sleeve, then install
sleeve.
9. Clean contact surface with the front axle and actuator
mounting surface. Apply liquid gasket to the contact
surface on the front axle case, then install in the
housing.
412RW023
10. Tighten bolts to specified torque.
Torque: 116N·m(85 lb ft)
11. Clean the actuator contact surface with the housing
then Install and tighten shift position switch to
specified torque.
Torque: 39N·m (29 lb ft)
12. Apply liquid gasket to the contact surface on the
actuator side.
412RW012
13. Align shift arm with the groove of sleeve and install the
actuator.
14. Tighten bolts to specified torque.
Torque: 13N·m(113 lb ft)
15. Install front axle drive shaft and mounting bracket.
Tighten fitting bolts to specified torque.
Torque: 116N·m (85 lb ft)
16. Pour specified amount of differential gear oil to filler
plug.
Front Differential
Oil Capacity: 1.4lit (1.48US qt)
Actuator Housing
Oil Capacity: 0.12lit(0.13US qt)
17. Install filler plug through gasket and tighten to
specified torque.
Torque: 7.8N·m (58lb ft)
4C–31
DRIVE SHAFT SYSTEM
Main Data and Specifications
General Specifications
Front drive axle oil capacity
1.4 liter (1.48 US qt)(Differential)
0.12 liter (0.13 US qt)(Actuator Housing:Shift on the fly)
Type of lubricant
GL–5 (Multi grade type) Refer to chart in General Information
Axle shaft type
Constant velocity joint(Birfield joint type and double offset joint)
Torque Specifications
E04RW004
4C–32
DRIVE SHAFT SYSTEM
Special Tools
ILLUSTRATION
TOOL NO.
TOOL NAME
J–39378
Remover and Installer;
Front Axle mount
bushing
J–37452
Remover and Installer;
Inner shaft bearing
J– 26941
Remover;Bearing needle
J–2619–01
Hammer; Sliding
J–41693
Installer; Oil seal
J–41694
Installer; Bearing needle
ILLUSTRATION
TOOL NO.
TOOL NAME
J–8092
Grip
4C–33
DRIVE SHAFT SYSTEM
Front Propeller Shaft
General Description
Since the propeller shaft is balanced carefully, welding or
any other modifications are not permitted.
Alignment marks should be applied to each propeller
shaft before removal.
401RW002
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст