Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 407
7A–41
AUTOMATIC TRANSMISSION (4L30–E)
3. Gently pull on the connector to check that it is
securely latched.
141RY00006
8. Disconnect transmission harness connector and clip.
Connector : Adapter case, mode switch, main case,
magnetic sensor, transfer switch (4
×
4), 2–4 actuator
(4
×
4) and car speed sensor.
9. Remove harness heat protector.
815RW002
10. Support transmission with a jack.
Remove rear mount nuts from third crossmember.
(4
×
4)
F07RW008
(4
×
2)
F07R100005
11. Remove third crossmember.
12. Disconnect transmission oil cooler pipes from A/T
side.
13. Remove oil pipe clamp and bracket from the
converter housing.
7A–42
AUTOMATIC TRANSMISSION (4L30–E)
14. Loosen oil cooler pipe clamp bolt at the engine mount
side.
(4
×
4)
253RY001
15. Remove select cable by disconnecting inner cable
from select lever and removing outer cable with
bracket.
256RW025
16. Remove starter.
17. Remove under covers from the transmission and
engine.
18. Remove flex plate torque converter fixing bolts (6
pieces) by turning crankshaft.
240RX010
19. Remove engine transmission fixing bolts.
20. Pull out transmission assembly from the engine.
21. Remove the rear mount rubber and propeller
protector assembly if required (4
×
2).
7A–43
AUTOMATIC TRANSMISSION (4L30–E)
Installation
1. Slowly raise transmission jack until front of the
transmission assembly is aligned with rear of the
engine. Attach the transmission assembly to the
engine.
2. Tighten engine transmission bolts as shown in the
figure.
F07R200004
3. Align the flex plate torque converter bolt boss with flex
plate hole by turning the torque converter. Install flex
plate torque converter bolts (6 pieces) by turning the
crankshaft.
Torque: 54 N
•
m (40 lb ft)
NOTE: Do not reuse the flex plate torque converter bolt.
240RX010
7A–44
AUTOMATIC TRANSMISSION (4L30–E)
4. Install under covers to the transmission and engine.
5. Install starter.
Torque: 40 N
•
m (30 lb ft)
6. Install select cable by connecting inner cable to select
lever and installing outer cable with bracket.
256RW025
7. Connect transmission oil cooler pipes to A/T.
Torque: 44 N
•
m (33 lb ft)
8. Install oil cooler pipe clamp and bracket to the
converter housing.
(4
×
4)
253RY001
9. Tighten oil cooler pipe clamp bolt at the engine mount
side.
10. Install third crossmember.
Torque: 116 N
•
m (85 lb ft)
11. Install rear mount nuts.
Torque: 50 N
•
m (37 lb ft)
(4
×
4)
F07RW008
(4
×
2)
F07R100005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст