Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1652
8F–50
BODY STRUCTURE
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Install the regulator handle as shown in the figure, if
equipped without power windows.
631RW005
2. Check to see that the window regulator operates
smoothly and the glass opens and closes properly.
3. Install the waterproof sheet tightly against the door
panel.
BODY STRUCTURE
8F–51
Rear Window Regulator, Glass and Glass Run
Parts Location
655R100001
EndOFCallout
Legend
(1) Glass Run
(2) Glass
(3) Fixed Glass
(4) Window Regulator
(5) Outside Handle
(6) Door Lock Assembly
(7) Speaker Bracket
(8) Speaker
(9) Bracket
(10) Rear Corner Garnish
(11) Door Trim Panel
(12) Power Window Switch and Pull Case/Window
Regulator Handle
(13) Inside Handle
(14) Waterproof Sheet
(15) Waist Seal
8F–52
BODY STRUCTURE
Removal
1. Disconnect the battery ground cable.
2. Remove the rear corner garnish.
• Pull the garnish to disconnect the retaining clip.
3. Remove the window regulator handle.
• Remove the clip on the rear side of the regulator
handle using a wire.
651RW003
4. Remove the screw while pulling the inside lever
toward you and then remove the inside handle.
5. Remove the 1 screw at the pull case.
655R100002
6. Pull out the trim panel at the 8 clip positions.
• Disconnect the power window switch connector.
655R100003
7. Remove the power window switch and pull case, if
equipped.
• Remove the fixing screws from back side of the
rear door trim panel.
8. Remove the bracket.
9. Disconnect the speaker harness connector.
10. Remove the speaker with the speaker harness
connector from the door inner panel.
11. Remove the waterproof sheet (1).
• Taking notice of the door harness, peel the
waterproof sheet off the door panel carefully.
651RS002
BODY STRUCTURE
8F–53
12. Remove the speaker bracket.
• Remove the six fixing screws.
13. Remove the fixied glass.
• Remove one bolt and screw as shown in the
figure, then pull it upward.
651RW002
14. Remove the glass.
• First, align the height of regulator to the access
hole. Remove 2 screws attaching bottom channel
and regulator, then remove the glass.
651RW006
• Remove the window glass by tilting it as
necessary.
651RW007
15. Remove the window regulator.
• Remove the window regulator fixing bolts and pull
the regulator out from the lower hole of the door
panel.
651RW005
16. Remove the glass run.
• Pull the glass run out from the door frame.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст