Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 726
6A–85
ENGINE MECHANICAL
6. Install oil gallery and tighten the bolts in 2 steps in the
order shown.
1st step : 29 N·m (22 lb ft)
2nd step : 55
°∼
65
°
012RS007
7. Install cylinder block side bolts (1) and tighten
crankcase bolts in sequence shown in the illustration.
Torque : 39 N·m (29 lb ft)
012RW005
8. Install oil pump assembly. Refer to “Oil Pump” in this
manual.
9. Install oil strainer and O-ring.
10. Install oil pipe and O-ring.
11. Install crankcase with oil pan.
1. Completely remove all residual sealant, lubricant
and moisture from the sealing surfaces. The
surfaces must be perfectly dry.
2. Apply a correct width bead of sealant (TB– 1207C
or its equivalent) to the contact surfaces of the
crankcase. There must be no gaps in the bead.
3. The oil pan must be installed within 5 minutes
after sealant application to prevent premature
hardening of sealant.
4. Tighten the bolts and nuts to the specified torque.
Torque : 10 N·m (87 lb in)
013RW010
Legend
(1) Portion Between Both Holes
(2) Bolt Hole Portions
12. Install cylinder head gasket.
13. Install cylinder head assembly. Refer to “Cylinder
Head” in this manual.
6A–86
ENGINE MECHANICAL
Main Data and Specification
General Specification
Specifications
Item
6VE1
Engine type, number of cylinders and arrangement
Water cooled, four cycle V6
Form of combustion chamber
Pent roof type
Valve mechanism
4-Cams, 4-Valves, DOHC Gear & Belt Drive
Cylinder liner type
Casted in cylinder drive
Total piston displacement
3494 cc
Cylinder bore x stroke
93.4mm x 85.0mm
(3.677 in x 3.346 in)
Compression ratio
9.1 : 1
Compression pressure at 300rpm
1370 kPa (199 psi)
Engine idling speed (rpm)
Non adjustable (750)
Valve clearance
Intake: 0.28 mm (0.11 in)
Exhaust: 0.30mm (0.12in)
Oil capacity
5.3 liters (5.6 U.S. q.t.)
Ignition timing
Non adjustable (20
°
BTDC at idle rpm)
Spark plug
K16PR–P11, PK16PR11, RC10PYP4
Plug gap
1.0 mm–1.1 mm(0.0394 in – 0.0433 in)
6A–87
ENGINE MECHANICAL
Torque Specifications
Ignition coil, Spark plug, Crankshaft position sensor and Under cover
E06RY001
6A–88
ENGINE MECHANICAL
Cylinder head cover, Cylinder head, Camshaft bearing cap, Common chamber, EGR valve and EGR pipe, Ion
sensing module
E06R200002
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст