Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 654
4C–42
DRIVE SHAFT SYSTEM
Reassembly (Except TOD 4
×
4)
401RW057
Legend
(1) Sleeve Yoke
(2) Seal
(3) Tube Assembly
1. Discard used seal and install new one.
2. Align the alignment marks and install tube assembly
to sleeve yoke.
4C–43
DRIVE SHAFT SYSTEM
Main Data and Specifications
General Specifications
Engine
6VE1(3.5 L)
Transmission
M/T
A/T
A/T with TOD
Construction
Hollow steel tube with yoke and spider type universal
joints.
Hollow steel tube with
constant velocty joints.
Outside diameter
40.0 mm (1.57 in)
40.0 mm (1.57 in)
40.0 mm (1.57 in)
Length
559 mm (22.01 in)
559 mm (22.01 in)
577 mm (22.72 in)
Torque Specifications
E04RW005
4C–44
DRIVE SHAFT SYSTEM
Rear Propeller Shaft
General Description
Since the propeller shaft is balanced carefully, welding or
any other modifications are not permitted.
Alignment marks should be applied to each propeller
shaft before removal.
401RW003
Rear Propeller Shaft and Associated Parts
401RW059
Legend
(1) Bolt, Nut and Washer
(2) Rear Propeller Shaft
(3) Bolt, Nut and Washer
Removal
1. Jack up the vehicle and support it on the chassis
stands.
2. Gear shift lever should be placed in neutral position
and parking brake released.
NOTE: Apply alignment marks on the flange at the rear
propeller shaft both front and rear side.
4C–45
DRIVE SHAFT SYSTEM
401RS023
3. Remove bolt, nut and washer (Rear axle side).
4. Remove bolt, nut and washer (Transfer side).
5. Remove rear propeller shaft.
Installation
NOTE: Never install the shaft assembly backwards.
1. Completely remove the black paint from the
connecting surface of flange coupling on each end of
propeller shaft. Clean so that no foreign matter will be
caught in between.
2. Align the mark which is applied at removal .
Install rear propeller shaft and tighten the bolts to the
specified torque.
Torque: 63 N·m (46 lb ft)
3. After installing the propeller shaft, be sure to apply
black paint (1) to exposed area (other than
connecting surface) of the entire surface of flange
coupling .
401RS022
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст