Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 902
7A–34
AUTOMATIC TRANSMISSION (4L30–E)
5. Install the under cover (3 pieces), and tighten the
bolts to the specified torque.
Torque: 8 N
•
m (69 lb in)
6. Install front crossmember.
Torque: 78 N
•
m (58 lb ft)
7. Install the starter, and tighten the bolts to the specified
torque.
Torque: 40 N
•
m (30 lb ft)
8. Connect transmission harness connectors to
transmission, transfer, and right catalytic converter.
9. Connect fuel pipe brackets to transmission side.
For 4
×
4 (TOD)
141RW001
7A–35
AUTOMATIC TRANSMISSION (4L30–E)
For 4
×
4
141RW027
7A–36
AUTOMATIC TRANSMISSION (4L30–E)
For 4
×
2
141RY001
10. Install transmission oil cooler pipe to transmission.
Torque: 44 N
•
m (33 lb ft)
11. Install oil pipe clamp to torque converter housing
bracket.
12. Tighten oil pipe clamp bolt at engine mount side.
13. Install right catalytic converter, tighten to the specified
torque.
Torque: 67 N
•
m (49 lb ft)
14. Install left catalytic converter assembly, and tighten
the bolts to the specified torque.
Exh. pipe to exh. manifold 67 N
•
m (49 lb ft)
Exh. pipe flange bolt 43 N
•
m (32 lb ft)
15. Install left seat belt tension rod.
Torque: 39 N
•
m (29 lb ft)
16. Connect two left side oxygen sensor connectors to
the transmission harness.
17. Install front exhaust silencer mounting nuts.
18. Install third crossmember, and tighten the bolts to the
specified torque.
Torque: 76 N
•
m (56 lb ft)
19. Install rear mount nuts, and tighten the bolts to the
specified torque.
Torque: 50 N
•
m (37 lb ft)
20. Remove the jack from the transfer case.
7A–37
AUTOMATIC TRANSMISSION (4L30–E)
21. Install harness protector.
815RW002
22. Install the front propeller shaft, and tighten the bolts to
the specified torque (4
×
4).
Torque: 63 N
•
m (46 lb ft)
23. Install the rear propeller shaft, and tighten the bolts to
the specified torque.
Torque: 63 N
•
m (46 lb ft)
24. Connect the shift control rod to selector lever
assembly.
25. Install the transfer protectors, and tighten the bolts to
the specified torque (4
×
4).
Torque: 37 N
•
m (27 lb ft)
26. Install the transfer control lever (4
×
4).
27. Install the selector lever assembly.
28. Connect the wiring harness connectors to front
console.
29. Install the front console.
30. Install the transfer control lever knob (4
×
4).
31. Connect the battery ground cable.
32. Install the engine hood.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст