Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1112
3D–10
REAR SUSPENSION
Upper Link
Upper Link and Associated Parts
460RW006
EndOFCallout
Removal
1. Remove fuel tank. Refer to Engine Fuel in Engine
section.
2. Remove the speed sensor cable from the upper link.
3. Remove bolt, nut, rubber plate and protector.
4. Remove upper link.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Upper link
2. Rubber bushing
• Remove the rubber bushing by using remover J–
43008.
460RY00006
Legend
(1) Bolt and Nut (Axle side)
(2) Rubber Plate
(3) Upper Link
(4) Protector (Left side only)
(5) Bolt (Frame side)
REAR SUSPENSION
3D–11
• Install the rubber bushing by using to installer J–
43008.
NOTE: When mounting rubber bushings, be sure not to
use grease on bushings or any other nearby part.
460RY00007
Installation
1. Install upper link. Make sure that the upper link is in
its correct position.
NOTE: When mounting upper link, be sure not to use
grease bushings or any other nearby part.
460RW012
2. Install bolt, nut, rubber plate and protector. Tighten
the bolts and nuts lightly, then retighten them to the
specified torque after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install speed sensor cable.
4. Install fuel tank.
3D–12
REAR SUSPENSION
Lateral Rod
Lateral Rod and Associated Parts
460RW007
EndOFCallout
Removal
1. Remove nut and washer.
2. Remove bolt and nut.
3. Remove lateral rod.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Lateral rod
2. Rubber bushing (Frame side)
• Remove the rubber bushing (Frame side) by
using remover J–39215.
901RW060
Legend
(1) Bolt and Nut (Frame side)
(2) Lateral Rod
(3) Nut and Washer (Axle side)
REAR SUSPENSION
3D–13
• Install the rubber bushing (Frame side) by using
Installer J–39215.
NOTE: When mounting rubber bushings, do not use
grease on bushings or any other nearby parts.
901RW061
3. Rubber bushing (Axle side)
• Remove the rubber bushing (Axle side) by using
remover J–39792.
901RW062
• Install the rubber bushing (Axle side) by using
installer J–39792.
901RW063
Installation
1. Install lateral rod and make sure that the lateral rod
is in its correct position.
NOTE: When mounting lateral rod, be sure not to use
grease on bushings or any other nearby part.
460RW008
EndOFCallout
2. Install bolt and nut (Frame side). Tighten the bolt
and nut lightly, then retighten them to the specified
torque after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install nut and washer (Axle side). Tighten the nut
lightly, then retighten the nut to the specified torque
after the vehicle is at curb height.
Torque: 78 N·m (58 lb ft)
Legend
(1) Frame Side
(2) Axle Side
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст