Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1036
EXTERIOR/INTERIOR TRIM
8J–29
Tailgate Trim Panel (LH)
Tailgate Trim Panel (LH) and Associated Parts
683RS002
Legend
(1) Tailgate Trim Panel (LH)
(2) Clip
(3) Tailgate Panel
(4) Cap and Screw
Removal
1. Disconnect the battery ground cable.
2. Remove the cap and screw.
3. Remove the tailgate trim panel (LH).
D
Pry the trim panel retainers free from the tailgate
panel.
684RS001
Installation
To install, follow the removal steps in the reverse order.
8J–30
EXTERIOR/INTERIOR TRIM
Tailgate Trim Panel (RH)
Parts Location
684RS002
Legend
(1) Tailgate Trim Panel
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate trim panel (RH).
D
Pry trim panel retainer free from the tailgate panel.
684RS003
Installation
1. Install the trim panel (RH).
D
Insert the retainer of the trim panel into the tailgate
panel and fix it securely.
EXTERIOR/INTERIOR TRIM
8J–31
Luggage Floor Box
Luggage Floor Box and Associated
Parts
643RS006
Legend
(1) Rear Seat
(2) Floor Carpet
(3) Luggage Floor Box
(4) Luggage Floor Box Cover
Remove
1. Fold the rear seat assembly to the front direction.
2. Remove the luggage floor box cover.
D
Remove the clips which connect the floor carpet
and the luggage floor box cover.
3. Remove the luggage floor box.
Installation
To install, follow the removal steps in the reverse order.
Rope Hook Set
Rope Hook Set and Associated Parts
676RS003
Legend
(1) Rope Hook Set
(2) Cover
(3) Luggage Floor Carpet
(4) Hook
Removal
1. Remove the rope hook set.
D
Open the hook cover and hook fixing bolt.
Installation
1. Install the rope hook set.
D
Tighten the hook fixing bolt to the specified torque.
Torque: 13 N·m (113 lb in)
8J–32
EXTERIOR/INTERIOR TRIM
Power Door Mirror System
General Description
The circuit consists of the starter switch, door mirror
control switch, folding switch, defogger switch and door
mirrors on both sides.
The door mirror switch consists of the control switch,
folding switch and defogger switch.
When the control switch is operated with the starter
switch at either “ACC” or “ON” position, the motors
incorporated in the door mirrors on both sides rotates to
allow the horizontal and vertical adjustment of mirror
angles.
The folding switch can be used to fold the mirror and
return it to its original position.
When turning on the door mirror defogger switch with the
starter switch at “ON” position, built-in heater in the mirror
is activated to perform the defogger function.
Door Mirror Switch Assembly
(Control Switch, Folding Switch and
Defogger Switch) Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly(2).
D
Remove four screws.
D
Remove the transmission shift lever knob.
D
Remove the transfer shift lever knob.
D
Disconnect the seat heater switch connectors (if so
equipped).
D
Disconnect the door mirror switch connectors.
D
Disconnect the power & winter switch connectors.
(A/T only)
3. Remove the door mirror switch assembly(1).
D
Push the lock from the back side of the front
console.
825R200089
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Depress the switch with your fingers until it locks
securely.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст