Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 42
2A–14 POWER–ASSISTED STEERING SYSTEM
1. Check and adjust the tire inflation pressures.
2. Park the vehicle on a level ground and move the front
of the vehicle up and down several times to settle the
suspension.
3. Make necessary adjustment with the adjusting bolt on
the height control arms.
Trim height: 119
±
5 mm (4.69
±
0.2 in)
Caster Adjustment
The caster angle can be adjusted by means of the caster
shims (1) installed between the chassis frame (2) and
fulcrum pins.
Caster angle: 2
°
30’
±
1
°
CAUTION: Left and right side must be equal within
30’.
450RW006
450RS002
NOTE: Difference of the caster shim front/rear thickness
should be 3.6 mm (0.142 in) or less. Overall thickness of
caster shim and camber shim should be 10.8 mm
(0.425 in) or less.
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 N·m 112 ( lb ft)
Camber Adjustment
The camber angle can be adjusted by means of the
camber shims (2) installed in position between the
chassis frame (1) and fulcrum pins
Camber angle: 0
°
±
30’
King pin inclination: 12
°
30’
±
30’
CAUTION: Left and right side must be equal within
30’.
450RW007
450RS005
POWER–ASSISTED STEERING SYSTEM
2A–15
NOTE: Overall thickness of caster shim and camber
shim should be 10.8 mm (0.425 in) or less.
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 N·m (112 lb ft)
Position of shims
Camber angle
Caster angle
Front side
Rear side
Camber angle
Caster angle
When added
When removed
Decreases
Decreases
Caster shim
When removed
When added
Increases
Increases
Caster shim
—
When removed
Unchanged
Decreases
—
When added
Unchanged
Increases
Camber shim
When added
Decreases
Unchanged
Camber shim
When removed
Increases
Unchanged
Toe-in Adjustment
1. To adjust the toe-in angle, loosen the lock nuts (2) on
the tie rod (1) and turn the tie rod. Turn both rods the
same amount, to keep the steering wheel centered .
Toe-in: 0 to +2 mm (0 to +0.08 in)
433RW003
2. Tighten the lock nut to the specified torque.
Torque: 98 N·m (72 lb ft)
2A–16 POWER–ASSISTED STEERING SYSTEM
Main Data and Specifications
General Specification
Caster
2
°
30’
±
1
°
Camber
0
°
±
30’
King pin inclination
12
°
30’
±
30’
Toe-in
0 to +2 mm (0 to +0.08 in)
Max. steering angle
inside
32.6
°
(+0
°
30’ to –2
°
30’ )
outside
31.8
°
Torque Specification
E02RX001
POWER–ASSISTED STEERING SYSTEM
2A–17
Special Tools
ILLUSTRATION
TOOL NO.
TOOL NAME
J–29877–A
Tester;
Power steering
J–39213
Adapter;
Power steering tester
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст