Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1615
LIGHTING SYSTEM
8A–3
Headlight Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the headlight bulb (3).
D
Disconnect the connector.
D
Remove the bulb cover (1).
D
Release the retaining ring (2).
CAUTION: Don not touch the headlight bulb with
your fingers. The oil on your fingers will leave a
residue which will shorten the life of the halogen
bulb. In order to prevent this problem, clean the bulb
lens before installing the headlight bulb.
821RY00063
Installation
To install, follow the removal steps in the reverse order.
noting the following point:
1. Make sure to set the retaining ring and the bulb cover.
If the set is incomplete, there is a possibility that the
water comes in the light.
Headlight Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the radiator grille (1).
D
Remove eight clips and a screw.
3. Remove the front combination light (3).
D
Remove three screws.
D
Disconnect the connector.
4. Remove the headlight assembly (2).
D
Disconnect the connector.
D
Remove four screws.
801RY00017
8A–4
LIGHTING SYSTEM
Installation
To install, follow the removal steps in the reverse order.
noting the following point:
1. After installing the headlight, be sure to adjust the
headlight aim.
Headlight Adjustment
Preparation
Place the vehicle with 1 person in driver seat on a level
surface and check to see if the inflation pressure of the
tires is correct, the lenses are clean, the battery is
sufficiently charged, and adjust to place vehicle by using
the screen.
1. Set a vertical screen on a level surface.
2. Toward the screen (1) from the bulb center mark of
the headlight, extend parallel lines to the floor. Mark
point (A) and (B) on the screen at the intersection of
parallel line and the screen.
3. Draw vertical lines through point (A) and (B) on the
screen.
801RY00021
4. Keep the vehicle (2) 3m (9.8 ft) apart from the screen
(1).
5. Draw a horizontal line through point (A) and (B) on the
screen (1).
801RY00022
6. Turn the headlight low beam on.
7. Adjust the CUTLINE 30 mm (1.18 in) below the
horizontal line (H).
8. Adjust the BENDING POINT to the vertical line (V).
NOTE: Always adjust vertical adjustment first.
801RY00023
LIGHTING SYSTEM
8A–5
Vertical Adjustment
Use a screwdriver for vertical adjustment.
801RY00019
Horizontal Adjustment
Use a screwdriver for horizontal adjustment.
801RY00018
8A–6
LIGHTING SYSTEM
Fog Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the fog light bulb (2).
D
Disconnect the connector (5).
D
Remove the cap (4).
D
Loosen the retaining clip (1).
D
Pull out the bulb (2).
D
Disconnect the terminal (3).
825RY00068
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст