Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1642
8F–10
BODY STRUCTURE
2. Rear bumper adjustment.
• When the bolts fixing rear bumper assembly are
tightened, adjustment should be made with shims
so that clearances shown in the figure below are
provided between the body (tailgate) (4) and the
rear bumper(5).
690RY00014
BODY STRUCTURE
8F–11
Parts Location (Spare tire mounted under floor model)
690R100002
EndOFCallout
Legend
(1) Protector
(2) Rear Mud Flap
(3) Bumper Bracket
(4) Rear Bumper Support
(5) Rear Bumper Slider Bracket
(6) Rear Corner Bumper
(7) Backber
(8) Rear Bumper Retainer
(9) Rear Bumper Reinforcement Assembly
(10) Rear Center Bumper
(11) Rear Bumper Assembly
(12) Rear Bumper Fixing Bolt
8F–12
BODY STRUCTURE
Removal
1. Disconnect the battery ground cable.
2. Remove the rear mud flaps.
• Remove the four bolts.
3. Remove the protectors.
• Remove the three clips on the right side and five
clips on the left side.
4. Remove the bumper brackets.
• Remove the two nuts.
5. Remove the rear bumper supports.
• Remove the nut and bolt.
6. Remove the rear bumper assembly(1).
• Remove the two bolts(2) from each side.
690RY00002
7. Remove the rear center bumper.
• Remove the ten clips from the step part and three
bolts from each upper and lower sides.
8. Remove the rear bumper retainers.
• Remove the two nuts from each rear bumper
retainer.
9. Remove the rear corner bumpers.
• Remove the three bolts from each rear corner
bumper.
10. Remove the rear bumper slider brackets(1).
• Remove the two screws(4) and two nuts(3), and
then remove claw caught in the washer(2).
690RY00010
11. Remove the backbers from the rear bumper
reinforcement assembly.
• Remove the three bolts at each backber.
Installation
To install, follow the removal steps in reverse order,
noting the following points:
1. Partially tighten the rear bumper bolts(2) (3) and
adjust the clearance between the body (tailgate)
and the rear bumper(1).
Then fully tighten the rear bumper bolts(2) (3).
Torque : 147 N·m (108 lb ft)
690RY00003
BODY STRUCTURE
8F–13
2. Rear bumper adjustment.
• When the bolts fixing rear bumper assembly are
tightened, adjustment should be made with shims
so that clearances shown in the figure below are
provided between the body (tailgate) (4) and the
rear bumper(5).
690R100001
3. Tighten the spare tire fixing bolts to the specified
torque.
Torque : 118 N·m (87 lb ft)
Rear Bumper Slider
Removal
1. Remove the rear bumper.
• Refer to Rear Bumper in this section.
2. Remove the rear bumper slider(1).
• Remove the three bolts(2).
690RW016
Installation
To install, follow the removal steps in reverse order,
noting the following point.
1. Apply chassis grease to the slider and the slider
bracket moving surface.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст