Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1645
8F–22
BODY STRUCTURE
3. Remove the front turn signal light assembly.
• Remove the fixing screw and disconnect the
connector.
801RY00005
4. Remove the front mud flap.
5. Remove the inner liner.
647RY00003
6. Remove the antenna assembly.
• Refer to Rod Type Antenna in Entertainment
section.
7. Remove the front fender panel.
• Remove the eight fixing bolts.
614RX001
8. Remove the front wheel arch moulding (If so
equipped).
• Refer to Wheel Arch Moulding in Exterior/Interior
Trim section.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Tighten the front fender panel fixing bolts to the
specified torque.
Torque : 7 N·m (61 lb in)
2. Check the fender and front door(1).
Clearance: 5.0 mm (0.196 in)
Height (step): Flush
610RY00002
BODY STRUCTURE
8F–23
610RW001
8F–24
BODY STRUCTURE
Body Mounting
Parts Location
501R200007
EndOFCallout
Tightening Torque
1. Tighten the body mounting bolts to specified torque.
Torque : 50 N·m (41 lb ft)
* mark position
(LWB) Torque : 50 N·m (41 lb ft)
(SWB) Torque : 103 N·m (76 lb ft)
Legend
(1) No.1 Body Mounting (LWB)
(2) No.1 Body Mounting (SWB)
(3) No.2 Body Mounting
(4) No.3 Body Mounting
(5) No.4 Body Mounting (LWB only)
(6) No.5 Body Mounting (LWB)
(7) No.5 Body Mounting (SWB)
(8) Body Side Mounting Bracket
(9) Frame Side Mounting Bracket
BODY STRUCTURE
8F–25
Body Dimension
Front Section
A10RW034
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст