Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1242
6E1–44
RODEO Y22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
15. Select F2: Low Fan Relay.
060RX048
16. Push “On” and “Off” of soft key.
17. Control Low Fan Relay and check a data list.
18. If the data list changes, the Low Fan Relay is normal.
19. Run the Fan Motor.
20. Select F3: High Fan Relay.
060RX049
21. Push “On” and “Off” of soft key.
22. Control High Fan Relay and check a data list.
If the data list changes, the High Fan Relay is normal.
23. Run the Fan Motor.
EVAP Test
This test is conducted check EVAP system for its working.
Tech 2 must be used for this test.
Test Procedure:
1. Connect Tech 2 to the vehicle DLC.
2. Run the Engine at idle.
3. Select F3: Miscellaneous Test in the Application
Menu.
060R100078
4. Select F2:EVAP Test in the Miscellaneous Test.
060RX050
6E1–45
RODEO Y22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
5. Select F0: Purge Solenoid.
060RX025
6. Push “Decrease” or “Increase” soft key.
060RX026
7. Control EVAP Purge Solenoid and check a data list.
8. If the data list changes, the purge Solenoid is normal.
Ignition SW is “On”.
9. Turn engine off, turn ignition SW “On”.
10. Select F1:EVAP Vent Solenoid.
060RX025
11. Push “On” or “Off” of soft key.
060R100019
12. Control EVAP Vent Solenoid and check a data list.
13. If the data list changes, the EVAP Vent Solenoid is
normal.
Idle Air Control System Test
This test is conducted check to IAC system for proper
operation.
Tech 2 must be used for this test.
Test Procedure:
1. Connect Tech 2 to the vehicle DLC.
2. Run the Engine at idle.
6E1–46
RODEO Y22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
3. Select F3: Miscellaneous Test in the Application
Menu.
060R100078
4. Select F3: IAC System Test in the Miscellaneous
Test.
060RX051
5. Select F1: IAC Control Test.
060RX052
6. Push “Increase” or “Decrease” soft key.
7. Control IAC system and check a data list.
D
F0: IAC Control
060RX015
8. Select F1: IAC Reset.
9. Push “Reset IAC” soft key.
10. Control IAC Reset and check data list.
6E1–47
RODEO Y22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
11. If data list changes, the IAC has been Reset.
060RW231–1
Fuel System Test
This test is conducted check Fuel Level Gauge for proper
operation.
Tech 2 must be used for this test.
Test Procedure:
1. Connect Tech 2 to the vehicle DLC.
2. Ignition SW is “On”.
3. Select F3: Miscellaneous Test in the Application
Menu.
060R100078
4. Select F4: Fuel System in the Miscellaneous Menu.
060RX053
5. Select F1: Fuel Gauge Level
060RX028
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст