Isuzu N-Series. Service manual — part 466
6E-200 EMISSION AND ELECTRICAL DIAGNOSIS
Exhaust Brake Malfunction (Exhaust Brake only)
N6A1679E
EMISSION AND ELECTRICAL DIAGNOSIS 6E-201
N6A1348E
6E-202 EMISSION AND ELECTRICAL DIAGNOSIS
N6A1349E
EMISSION AND ELECTRICAL DIAGNOSIS 6E-203
Inspection
1. Exhaust Brake Magnetic Valve
Inspection
Connect the magnetic valve connector terminal
No.1 and No.2 to (+) terminal and (-) terminal of
battery, respectively, and check the continuity be-
tween the ports.
Caution:
When measuring resistance with a circuit tester, be
careful not to damage or deform the terminals.
2. Exhaust Throttle Valve
Working Check
Actuate the exhaust brake with the engine idling
and make sure that you hear the valve strike on the
stopper.
Airtight Check
Apply a negative pressure of 53.3 — 93.3 kPa (400
— 700 mmHg/7.73 — 13.54 psi) to the power
chamber by means of a vacuum pump and make
sure of the smooth opening/closing of the exhaust
brake valve.
Apply a negative pressure of 86.7 — 93.3 kPa (650
— 700 mmHg/12.57 — 13.54 psi) to the power
chamber using a vacuum pump and make sure the
average of measurements at Point A and Point B
of the clearance between valve and body is as fol-
lows:
0.4 — 0.6 mm (0.016 — 0.024 in) (Minimum: 0.4
mm/0.016 in)
If the clearance is out of this range, adjust with the
adjusting bolt.
Legend
A. Inlet (Vacuum pump)
B. Outlet (unit)
C. EXH (air filter)
N6A1247E
N6A1248E
Legend
1. Power chamber
2. Adjust bolt
3. Valve
4. Close
N6A1249E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст