Isuzu N-Series. Service manual — part 22
0A-6 GENERAL INFORMATION
Rear Side Lifting Point
Notice:
Do not lift or support on rear axle tube.
Rear Side Supportable Point
N0A0012E
N0A0013E
GENERAL INFORMATION 0A-7
TORQUE SPECIFICATIONS
Standard Bolts
The torque values given in the following table should be applied where a particular torque is not specified.
N
⋅m (kg⋅m / lb⋅ft)
N
⋅m [kg⋅cm / lb⋅in]
The asterisk * indicates that the bolts are used for female-threaded parts that are made of soft materials such as cast-
ing, etc.
Flare Nuts
N
⋅m (kg⋅m / lb⋅ft)
Pipe diameter mm (in)
Torque
Pipe diameter mm (in)
Torque
4.76 (0.187)
16 (1.6 / 12)
10.00 (0.94)
54 (5.5 / 40)
6.35 (0.250)
26 (2.7 / 20)
12.00 (0.472)
88 (9.0 / 65)
8.00 (0.315)
44 (4.5 / 33)
15.00 (0.591)
106 (10.8 / 78)
N0A0023E
0A-8 GENERAL INFORMATION
RECOMMENDED LIQUID GASKET
Recommended Liquid Gasket
*RTV: Room Temperature Vulcanizer
Notice:
1. It is very important that the liquid gaskets listed above or their exact equivalent be used on the vehicle.
2. LOCTITE 515 and LOCTITE 518 harden upon contact with a metal surface.
Do not apply LOCTITE 515 or LOCTITE 518 between two metal surfaces having a clearance of greater than
0.25 mm (0.001 in). Poor adhesion will result.
3. Be careful to use the specified amount of liquid gasket.
Follow the manufacturer’s instructions at all times.
TYPE
BRAND NAME
MANUFACTURER
APPLICATION PARTS (EXAMPLE)
RTV*
ThreeBond 1207B
ThreeBond
Engine Oil Seal Retainer
Silicon
ThreeBond 1207C
ThreeBond
Engine Oil Pan
ThreeBond 1215
ThreeBond
Timing Gear Case
ThreeBond 1216
ThreeBond
Cylinder Head Cover
ThreeBond 1281
ThreeBond
Fuel Pump
Water Base
ThreeBond 1141E
ThreeBond
Rear Axle
Solvent
ThreeBond 1104
ThreeBond
etc.
BelcoBond 4
Isuzu
BelcoBond 401
Isuzu
BelcoBond 402
Isuzu
Anaerobic
LOCTITE 515
LOCTITE
Engine Oil Seal Retainer
LOCTITE 518
LOCTITE
Water Pump
Transaxle
etc.
GENERAL INFORMATION 0A-9
Application Procedure
1. Completely remove lubricant and moisture from the connecting surfaces.
The surfaces must be perfectly dry.
2. Apply specified bead width of liquid gasket to one of the connecting surfaces.
Notice:
When the application procedures are specified in this manual, follow them.
N0A0014E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст