Isuzu N-Series. Service manual — part 1011
CAB AND CHASSIS ELECTRICAL 8-149
3. Cornering Light
3-1. Both Cornering Lights Inoperative
N8A0129E
8-150 CAB AND CHASSIS ELECTRICAL
3-2. Cornering Light on The Left (or Right) Side Inoperative
Notice:
Figures in parenthesis “( )” indicate place of inspection for the cornering light on the right.
3-3. Cornering Light Remains on Even when Steering Wheel is in Straight Ahead Position
N8A5149E
• DOES THE CORNERING LIGHT SWITCH OPERATE
SMOOTHLY?
NO
REPAIR OR REPLACE THE CORNERING LIGHT
SWITCH (COMBINATION SWITCH)
N8A0131E
CAB AND CHASSIS ELECTRICAL 8-151
4. Rear Fog Light
4-1. Rear Fog Light Inoperative (while Headlight is On)
• IS THE REAR FOG LIGHT BULB NORMAL?
• IS FUSE FOG LIGHT (REAR) F-27 (15A) NORMAL?
YES
NO
REPLACE THE BULB
• IS J-9 GROUNDED SECURELY?
YES
NO
REPLACE THE FUSE
• ARE THE REAR FOG LIGHT AND HEAD LIGHT RELAYS
NORMAL?
YES
NO
GROUND IT SECURELY
YES
NO
REPAIR OR REPLACE THE RELAY
• DISCONNECT THE REAR FOG LIGHT SWITCH
CONNECTOR
• IS THERE ANY CONTINUITY BETWEEN THE SWITCH
CONNECTORS 1 B-70 AND 14 B-70 WHEN THE
SWITCH IS ON?
YES
NO
CONTINUED ON THE FOLLOWING PAGE
YES
NO
REPAIR A POOR CONNECTION AT THE
CONNECTORS OR AN OPEN CIRCUIT BETWEEN
4 X-3 AND 1 B-70
• RECONNECT THE RELAYS AND REAR FOG LIGHT
SWITCH CONNECTOR
• IS THERE A BATTERY VOLTAGE APPLIED BETWEEN
SWITCH HARNESS SIDE CONNECTOR 1 B-70 AND
GROUND WHEN REAR FOG LIGHT SWITCH IS ON?
REPAIR OR REPLACE THE SWITCH
N8A0132E
8-152 CAB AND CHASSIS ELECTRICAL
Starter Switch
Refer to “START AND CHARGING” in this section.
High Beam Indicator Light
Refer to “METER AND WARNING/INDICATOR LIGHT”
in this section.
Headlight Bulb Replacement
Removal
1. Remove the battery ground cable at the battery.
2. Remove the headlight assembly. (Refer to ‘Head-
light Replacement’ below.)
3. Remove the headlight bulb.
• Remove the dust cover (3).
• Remove the clip (1).
• Remove the headlight bulb (2).
Caution:
Do not touch the glass portion of the bulb with your fin-
gers.
Installation
1. Install the headlight bulb.
• Set the headlight bulb (2).
• Fix the headlight bulb with clip (1).
• Install the dust cover (3).
2. Install the headlight assembly.
(Refer to ‘Headlight Replacement’ below.)
3. Connect the battery ground cable at the battery.
4. Check if the light lights.
N8A0133E
1
2
3
N8A5468E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст