Isuzu N-Series. Service manual — part 185
FRONT AXLE 4C-35
6. Key Bolt
Tighten:
Key bolt to 32 N
⋅m (3.3 kg⋅m / 24 lb⋅ft)
7. King Pin Cover
8. Plate Plug
Drive the plate plug upward into position with an
appropriate bar fitted against the lower end.
9. Tie Rod Arm
10. Knuckle Arm
Tighten:
Knuckle arm nut to 441 N
⋅m (45 kg⋅m / 325 lb⋅ft)
After tightening, stake nut.
Use a new nut.
11. Tie Rod Assembly
Use a new nut.
Tighten:
Tie rod end nut to 186 N
⋅m (19 kg⋅m / 137 lb⋅ft)
Be sure to install a new cotter pin. If the hole and the slot
are not aligned, turn in the direction of tightening to align
them.
N4A0320E
N4A0321E
N4A0322E
N4A0323E
4C-36 FRONT AXLE
12. Wheel Brake Assembly
13. Cover
Tighten:
Wheel brake bolt to 69 N
⋅m (7 kg⋅m / 51 lb⋅ft)
14. Hub with Brake Drum
15. Wheel and Tire
N4A0324E
N4A0325E
FRONT AXLE 4C-37
Free Wheel Hub (Manual Locking Hub) (4
× 4 Model)
Legend
1. Screw
10. Handle
2. Cover assembly
11. Ring
3. Snap ring and shim
12. Cover
4. Bolt
13. Inner snap ring
5. Body assembly
14. Body
6. Clutch assembly
15. Outer snap ring
7. Inner snap ring
16. Ring
8. Tension spring
17. Spacer
9. Inner snap ring
18. Inner hub lock
N4A0326E
4C-38 FRONT AXLE
Removal
1. Screw
2. Cover Assembly
Set handle into “FREE” position and then remove
cover assembly.
(During removal, take care not to damage the
flange on rear side of cover. Remove wheel (tire)
as necessary.)
3. Snap Ring and Shim
Confirm the quantity of shims.
4. Bolt
5. Body Assembly
Remove the body assembly using a push bolt (M10
× 1.5).
During removal, do not damage the flange of body
by hitting with a screwdriver or the like.
6. Clutch Assembly
1) With the handle in FREE position, hold the cov-
er and rotate fully the clutch assembly clock-
wise as shown (A).
At this time, the lug of clutch retainer gets stuck
by the L-shaped part at the edge of tension
spring (0 it is pinched by double parts of tension
spring).
2) Under the condition of 1) above, rotate further
the clutch assembly clockwise while pushing it
(B).
Consequently, the clutch retainer lug is freed
from the L-shaped part at the edge of tension
spring (C).
Do not try to further disassemble the clutch as-
sembly.
7. Inner Snap Ring
8. Tension Spring
Remove the snap ring and then remove the tension
spring from the cover.
9. Inner Snap Ring
10. Handle
Remove the inner snap ring and then remove the
handle from the cover.
N4A0327E
N4A0328E
N4A0329E
N4A0330E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст