Isuzu N-Series. Service manual — part 72
1D2-12 COMPRESSOR OVERHAUL FOR TAIWAN
19. Pulley Assembly
Using pulley installer and drive handle to install the
pulley assembly.
Pulley Installer: 5-8840-0118-0 (J-33940)
Drive Handle: 5-8840-0007-0 (J-8092)
20. Cover (If so equipped)
21. Snap Ring
Install the snap ring with the inside indented portion
facing out.
22. Shim(s)
23. Drive Plate
Install the drive plate to the compressor drive shaft
together with the original shim(s).
Press the drive plate by hand.
24. Drive Plate Bolt
Using drive plate holder to prevent the drive plate
from rotating.
Drive Plate Holder: 5-8840-0117-0 (J-33939)
Tighten the bolt to the specified torque.
Tighten:
Drive plate bolt to 15 N
⋅m (0.5 kg⋅m / 11 lb⋅ft)
N1A0117E
N1A0118E
N1A0119E
N1A0120E
COMPRESSOR OVERHAUL FOR TAIWAN 1D2-13
After tightening the bolt, check to be sure the pulley
rotates smoothly.
Check to be sure that the clutch clearance is be-
tween 0.3 — 0.6 mm (0.01 — 0.02 in).
If necessary, install adjusting shim(s).
Adjusting shims are available in the following thick-
ness.
Thickness
0.1 mm (0.0039 in)
0.3 mm (0.0118 in)
0.5 mm (0.0197 in)
N1A0101E
N1A0122E
International Service & Parts
Tokyo, Japan
WORKSHOP MANUAL
N-SERIES
FRAME AND CAB
SECTION 2
SERVICE INFORMATION 00-1
FRAME AND CAB
SECTION 00
SERVICE INFORMATION
Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст