Isuzu Trooper (2000 year). Service manual — part 480
8F–67
BODY STRUCTURE
Rear Door Seal Finisher
Parts Location
655RS002
Legend
(1) Rear Door Sill Plate and Luggage Side Lower
Cover
(2) Rear Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove rear door sill plate and the luggage side
lower cover.
3. Remove rear door seal finisher (1).
D
Pull the rear door seal finisher (1) out from the body
panel.
635RS003
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Insert the rear door seal finisher (2) into the A corner
and install the finisher in the arrow-marked directions.
2. Be careful not to allow the sill plate and cover (1) to
distort or twist the finisher.
655RS002
8F–68
BODY STRUCTURE
Tailgate Assembly (LH)
Parts Location
681RT001
Legend
(1) Tailgate Fixing Bolt
(2) Tailgate Hinge
(3) Tailgate Harness Connection
(4) Tailgate Stopper Assembly
(5) Tailgate Trim Panel (LH)
(6) Tailgate Assembly (LH)
Removal
1. Disconnect the battery ground cable.
2. Remove tailgate time panel (LH).
D
Refer to Tailgate Trim Panel (LH) in Exterior /
Interior Trim section.
3. Remove tailgate stopper assembly
4. Remove tailgate harness connection.
D
Open the luggage trim panel lid and disconnect the
tailgate harness connection.
810RS003
8F–69
BODY STRUCTURE
5. Remove tailgate fixing bolts.
681RS002
6. Remove tailgate assembly (LH).
7. Remove tailgate hinge.
D
Apply a setting mark (1) on the body side hinge and
remove the hinge fixing bolts.
681RW007
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply chassis grease to the tailgate hinge and the
tailgate stopper moving surface.
2. Align the tailgate fitting to the body by referring to
Body Dimension in this section.
3. Tighten the hinge bolts to the specified torque.
Torque : 34 N
•
m (25 lb ft)
8F–70
BODY STRUCTURE
Tailgate Assembly (RH)
Parts Location
681RS004
Legend
(1) Tailgate Assembly (LH)
(2) Tailgate Trim Panel (RH)
(3) Tailgate Harness Connection
(4) Rear Combination Light (RH)
(5) Tailgate Fixing Bolt
(6) Tailgate Hinge
Removal
1. Disconnect the battery ground cable.
2. Remove rear combination light (RH).
3. Remove tailgate trim panel (RH).
D
Refer to Tailgate Trim Panel (RH) in Exterior /
Interior Trim section.
4. Remove tailgate harness connection.
D
Disconnect the tailgate harness connection.
810RS004
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст