Isuzu Trooper (2000 year). Service manual — part 68
3D–10
REAR SUSPENSION
Lateral Rod
Lateral Rod and Associated Parts
460RW019
Legend
(1) Bolt and Nut
(2) Nut and Washer
(3) Lateral Rod
Removal
1. Remove nut and washer.
2. Remove bolt and nut.
3. Remove lateral rod.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Lateral rod
2. Rubber bushing (Frame side)
D
Remove the rubber bushing (Frame side) by using
remover J–39214.
901RW060
3D–11
REAR SUSPENSION
D
Install the rubber bushing (Frame side) by using
Installer J–39215.
NOTE: When mounting rubber bushings, do not use
grease on bushings or any other nearby parts.
901RW061
3. Rubber bushing (Axle side)
D
Remove the rubber bushing (Axle side) by using
remover J–39792.
901RW062
D
Install the rubber bushing (Axle side) by using
installer J–39792.
901RW063
Installation
1. Install lateral rod and make sure that the lateral rod is
in its correct position.
NOTE: When mounting lateral rod, be sure not to use
grease on bushings or any other nearby part.
460RS016
Legend
(1) Frame Side
(2) Axle Side
2. Install bolt and nut. Tighten the bolt and nut lightly,
then retighten them to the specified torque after the
vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install nut and washer. Tighten the nut lightly, then
retighten the nut to the specified torque after the
vehicle is at curb height.
Torque: 78 N·m (58 lb ft)
3D–12
REAR SUSPENSION
Stabilizer Bar
Stabilizer Bar and Associated Parts
460RW020
Legend
(1) Nut and Washer
(2) Link
(3) Bracket
(4) Rubber Bushing
(5) Stabilizer Bar
Removal
1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove nut and washer.
4. Remove link.
CAUTION: Be careful not to damage the ball joint
boot.
5. Remove bracket.
6. Remove rubber bushing.
7. Remove stabilizer bar.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D
Stabilizer bar
D
Rubber bushing
D
Link ball joint
3D–13
REAR SUSPENSION
Installation
1. Install stabilizer bar.
2. Install rubber bushing.
3. Install bracket and tighten to the specified torque.
Torque: 22 N·m (16 lb ft)
4. Install link.
5. Install nut and washer, then tighten the nut to the
specified torque.
Torque: 50 N·m (37 lb ft)
460RS018
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст