Isuzu Trooper (2000 year). Service manual — part 142
4D2–10 TRANSFER CASE (TOD)
6. Remove the offset lever set bolt on the right side.
261RW015
7. Remove the offset lever lock spring pin.
NOTE: When removing the spring pin, pay attention to
the recess position of the pin.
261RW016
8. Remove the offset lever.
261RW017
9. Remove the sixteen bolts and detach the transfer
cover assembly from the transfer cable assembly.
NOTE: When removing the transfer cover assembly, pay
attention not to damage the oil seal.
Reassembly
1. Apply liquid gasket (Loctite 598 or equivalent)
uniformly to the mating face that contacts the transfer
case.
261RW023
4D2–11
TRANSFER CASE (TOD)
2. Tighten the sixteen bolts with the specified torque.
Torque : 31 N·m (23 lb ft)
3. Wind the sealing tape around the drain plug thread
and tighten the plug with the specified torque.
Torque : 25 N·m (18 lb ft)
4. Install offset lever.
5. Mount the offset lever to the transfer shift and attach
the spring pin.
261RW016
6. Install rear and front companion flange.
7. Attach the O-ring and washer to the companion
flange.
NOTE: Securely push the O-ring to the dent of the
companion flange, and then attach the washer.
8. Use the flange holder J-8614-11 to tighten the flange
nuts to transfer case.
9. Tighten the flange nut with the specified torque.
Torque : 167 N·m (123 lb ft)
10. Using the punch J-39209, securely stake the flange
nut at two places
NOTE: Check the staked flange nut is free from cracks.
266RW020
260RW007
11. Fix the harness with the clip.
12. Tighten the 4L and 4H switch to the specified torque.
Torque : 16 N·m (12 lb ft)
13. Fill the transfer case with ATF II or III (1.9 liters).
14. Wind the sealing tape around the filler plug thread and
tighten the plug with the specified torque.
Torque : 25 N·m (18 lb ft)
4D2–12 TRANSFER CASE (TOD)
Transfer Cover Assembly
Disassembled View
261RW007
Legend
(1) Coil Assembly
(2) Snap Ring
(3) Ball Bearing
(4) Speed Gear and Tone Wheel
(5) Ball Bearing
(6) Transfer Cover Assembly
(7) Front and Rear Speed Sensors
Disassembly
1. Using snap ring pliers, remove the snap ring.
261RW047
4D2–13
TRANSFER CASE (TOD)
2. Remove ball bearing.
3. Strike the speed gear and tone wheel with a rod or
other appropriate tool from the outside of the transfer
cover assembly, and remove the ball bearing and
speed gear and tone wheel.
NOTE: Pay attention not to damage the speed gear
teeth.
266RW018
4. Remove the stopper plate on the back with a
precision screwdriver or other appropriate tool
starting from the small lock of the plate.
NOTE: Pay attention not to damage the stopper plate
during the work.
261RW042
5. Using a terminal pull-out tool or an equivalent tool,
push down the lock to unlatch the terminal for the coil
assembly, and pull the terminal out.
NOTE: Pay attention not to damage other terminals.
261RW032
6. Remove the set bolts of the cam&coil housing from
the outside of the transfer cover assembly. Remove
the housing from the transfer cover.
261RW030
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст